Dell PowerVault TL4000 Ek Talimatları - Sayfa 11

Depolama Dell PowerVault TL4000 için çevrimiçi göz atın veya pdf Ek Talimatları indirin. Dell PowerVault TL4000 17 sayfaları. Tape library
Ayrıca Dell PowerVault TL4000 için: Sürüm Notları (3 sayfalar), Başlarken (38 sayfalar), SSS (26 sayfalar), Hızlı Başlangıç Kılavuzu (7 sayfalar), Yazılım Kılavuzu (16 sayfalar), Yapılandırma Kılavuzu (22 sayfalar), Önemli Bilgiler Kılavuzu (10 sayfalar), Kullanıcı Kılavuzu Eki (2 sayfalar), Başlangıç Kılavuzu (3 sayfalar), Broşür (4 sayfalar), Kullanıcı Kılavuzu (20 sayfalar)

iSCSI for TL-Series Tape Libraries

SEPTEMBER 2008

Note: If Jumbo Frames are enabled, they must be enabled for all devices across the network

(including the host, target, and any switches or routers in between). Jumbo frame sizes will

allow for greater packet payloads and lower overhead traffic, resulting in likely performance

increases.

Note: If the ICMP "PING" command will be used to network connectivity, the "Enable ICMP

PING responses" checkbox must be checked.

After these settings have been enabled, the Windows iSCSI initiator on the host computer can

be used to perform discovery of the MD3000i target. After the iSCSI initiator on the host has

discovered the MD3000i, go to the "Configure" tab on the MDSM and select "Configure Host

Access - Manual". Enter the host name into the configuration, select the operating system,

and select "Next". This will guide the user to a screen to select iSCSI initiators. If a known

initiator is displayed, highlight it, click "Add", and then "Next". Otherwise, select "New" and

enter the iSCSI initiator name and select "Next". After selecting whether the host is on a Micro-

soft cluster, click "Finish".

If CHAP is going to be used in the iSCSI network, it can be enabled at this point under the

"iSCSI" tab under the "Change Target Authentication" and "Enter Manual Authentication Per-

missions" selections in MDSM.

SECTION 7

BACKUP EXEC 12 FOR WINDOWS SERVER INSTALLATION

Symantec offers a good backup solution for SAN based environments and can easily be con-

figured for iSCSI. Symantec recommends that you have connected all of the I/O controllers,

tape hardware devices, and other storage devices to the system where Backup Exec will be

installed before beginning the Backup Exec installation. Before installing Backup Exec 12 for