Dell PS4110 Donanım Kullanım Kılavuzu - Sayfa 21
Depolama Dell PS4110 için çevrimiçi göz atın veya pdf Donanım Kullanım Kılavuzu indirin. Dell PS4110 48 sayfaları. Storage arrays
Ayrıca Dell PS4110 için: Kullanıcı Kılavuzu (20 sayfalar), Donanım Kılavuzu (50 sayfalar), Genel Bakış (7 sayfalar), Kurulum (2 sayfalar)
Sayfayı Yazdır
3 Maintaining Control Modules
Different PS Series array models contain different control module types. The combination of chassis type,
control module pair, and drives determines the PS Series array model number.
The control modules in a PS Series array contain the PS Series firmware which provides the Group Manager
GUI, the command line interface, and all the array and storage management functions and features.
Ideally, an array has two control modules (which must be of the same type) to avoid a single point of failure for
the array.
A PS4110 array includes one or two hot-swappable Type 17 control modules.
One functioning control module is required for array operation. You access control modules from the rear of the
array.
Control Module Features
The Type 17 control module includes:
•
Two 10G Ethernet ports, both labeled Ethernet 0. Each port has its own LEDs indicating status and activity:
–
One 10GBASE-T port
–
One SFP+ port
Note:
Only one 10G Ethernet port can be used at a time. If both ports are attached to an active switch, the
control module will prefer to communicate over the SFP+ interface.
•
One 10Mb/100Mbps port, labeled MANAGEMENT - for use only if you configure a management network.
The management port has two LEDs to indicate status and activity.
on page 31
for more information.
•
A column of LEDs labeled PWR (power), ERR (error condition) and ACT (activity) that indicate the status
of the control module.
•
A recessed button labeled STANDBY ON/OFF that allows you to quickly shut down the array in certain cir-
cumstances. See
About the Standby On/Off Button on page 22
•
One serial port (for use if there is no network access to the array).
•
A field-replaceable microSD card containing the PS Series firmware. The microSD card is accessed from
the rear of the control module.
See "Configuring the Management Port"
for more information.
17