3 Day Blinds Faux Wood 1 Başlarken - Sayfa 4

Pencere Panjurları 3 Day Blinds Faux Wood 1 için çevrimiçi göz atın veya pdf Başlarken indirin. 3 Day Blinds Faux Wood 1 6 sayfaları.

Sayfayı Yazdır

BLIND INSTALLATION

• If you have not already done so unwrap the cellophane

from around the blind stack. Caution: DO NOT cut the

cellophane as the cords or ladders supporting the blind may

be inadvertently cut.

• While supporting the bottom of the blind, unwind the draw

cords and gently lower the blind to its full length. (See

"Operating the Blind".)

NOTE: If the bracket interferes with any of the working parts,

the incorrect holes of the end mount bracket may have been

selected.

| 1" Faux Wood Blinds

• If you ordered the blind

with a valance, snap the

valance clips to the front

of the headrail before

installing the blind. The

valance clips should be

spaced equidistant from

the end brackets and each

other to allow proper

support for the entire

valance. Make sure that

the Valance Clips do not

interfere with any moving

parts. You will install the

valance slat after the blind

is in place.

• Be sure the hinged end

brackets are in the open

position.

• Hook the front edge of

the headrail onto the lip

of the center support

bracket(s), if applicable.

Insert the headrail into the

end brackets, making sure

that no cords or slats are

in the way.

• Close the hinges on the

end brackets until you

hear them "snap."

VALANCE RETURN

NOTE: If you did not order valance returns for your blind,

proceed to "Valance Installation" below.

CAUTION: Do not get glue on the painted/stained surface of

the valance. Avoid contact with skin.

• Join the ends of the valance returns with the valance by

pressing the mitered edges together firmly for 60 seconds.

• Repeat this procedure for the other end of the valance.

• Allow the glue to dry for at least 10 minutes before installing

the valance. Proceed to "Valance Installation" below.

VALANCE INSTALLATION

Make sure the valance clips have been attached to the

headrail as noted in "Blind Installation".

without valance returns

• Center the valance on the headrail.

• Apply a thin coat of glue

to the mitered end of

both the valance and the

valance returns.

with valance returns

• Insert the top edge of the

valance into the top lip of

the valance clips. Using a

downward rolling motion,

gently push the bottom

edge of the valance into

the valance clips until

you hear the valance

"snap" into place.