Dell Force10 S4810 Hızlı Başlangıç Kılavuzu - Sayfa 17
Anahtar Dell Force10 S4810 için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Dell Force10 S4810 27 sayfaları. Dell force10 s4810 switch
Ayrıca Dell Force10 S4810 için: Dağıtım Kılavuzu (36 sayfalar), Yapılandırma Kılavuzu (17 sayfalar), Yapılandırma Kılavuzu (17 sayfalar)
Sayfayı Yazdır
Installing the Software
Navigating CLI Modes
The FTOS prompt changes to indicate the CLI mode. You must move linearly
through the command modes, with the exception of the end command which
takes you directly to EXEC Privilege mode; the exit command moves you up
one command mode level.
Console Access
NOTE: Before starting this procedure, be sure you have a terminal emulation
program already installed on your PC.
The RS-232 console port is labeled on the S4810 chassis. It is in the upper right-
hand side, as you face the I/O side of the chassis.
RJ-45
Console Port
Step
Task
Install an RJ-45 copper cable into the console port. Use a rollover cable to
1
connect the S4810 console port to a terminal server.
Connect the other end of the cable to the DTE terminal server.
2
Default terminal settings on the console port are set as follows:
3
9600 baud rate
No parity
8 data bits
1 stop bit
No flow control
Installing the Software
2
13