Dell Force10 S4810 Dağıtım Kılavuzu - Sayfa 17

Anahtar Dell Force10 S4810 için çevrimiçi göz atın veya pdf Dağıtım Kılavuzu indirin. Dell Force10 S4810 36 sayfaları. Dell force10 s4810 switch
Ayrıca Dell Force10 S4810 için: Hızlı Başlangıç Kılavuzu (27 sayfalar), Yapılandırma Kılavuzu (17 sayfalar), Yapılandırma Kılavuzu (17 sayfalar)

Sayfayı Yazdır

Idle Timeout: 0 seconds, Internal Idle Timeout: 0 seconds

Packets: -, Bytes: -

Match Parameters:

Valid Match: DMAC,Vid

In Port

: *

SMAC

: *

VLAN id

: 200

IP TOS

: *

Src IP

: *

Src Port

: *

Actions:

Output: Te 0/1

For complete L2 flow formats, refer to

Learning Bridge (LB) Flows

Learning bridge flows are only supported on OF VLANs. In the example below, of-instance 2 represents an LB flow. To

use the LB flow table, you must enable the multiple-fwd-table and learning-switch-assist commands,

as shown below. If you do not enable either command, LB flows are added to the ACL table.

FTOS#show running-config openflow of-instance 2

openflow of-instance 2

controller 1 10.11.205.184 tcp

flow-map l2 enable

flow-map l3 enable

interface-type vlan

learning-switch-assist enable

multiple-fwd-table enable

no shutdown

The example below shows a sample flow in of-vlan 200:

FTOS#show openflow flows of-instance 2

Instance: 2, Table: lb, Flow: 5, Cookie: 0xffffffffac2dbc22

Priority: 32768, Internal Priority: 0

Up Time: 0d 00:00:03, Hard Timeout: 0 seconds

Idle Timeout: 0 seconds, Internal Idle Timeout: 0 seconds

Packets: -, Bytes: -

Match Parameters:

Valid Match: InPort,SMAC,DMAC,Vid

In Port

: Te 0/0

SMAC

: 00:00:00:00:00:11

VLAN id

: 200

IP TOS

: *

Src IP

: *

Src Port

: *

Actions:

Output: Te 0/1

For complete LB flow formats, refer to

Packet Trace

Enable OpenFlow protocol packet tracing by using the debug openflow packets packet-type {of-id}

command.

EType

: *

DMAC

: 00:22:22:22:22:22

VLAN PCP

: *

IP proto

: *

Dest IP

: *

Dest Port : *

FlowTypes