Dell N20 Series Kurulum Kılavuzu - Sayfa 19

Anahtar Dell N20 Series için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Dell N20 Series 48 sayfaları.

•

An IP address is configured for the VLAN 1 routing interface.

•

A default gateway address is configured.

In the following example, the possible user options or default values are enclosed in [ ]. If you press Enter without defining options, the

default value is accepted. Help text is in parentheses.

Performing Initial Configuration on Dell Networking OS

9.11(0.0)

Before proceeding, ensure that the C9010 switch runs Dell Networking OS version 9.11(0.0) or later.

The following section explains the procedure to set up an N20xx switch if it runs the Dell Networking OS version 9.11(0.0) or later:

To complete the hardware installation, install the system in a rack, attach an uplink cable to a parent C9010 switch, set up an N20xx stack

if required, and power on the port extender.

To provision an N20xx system, configure basic software settings from the C9010 console either before or after you connect the N20xx to

a C9010. For example, you can preconfigure software settings to download from the parent C9010 after you power on the N20xx.

Provisioning preconfigured N20xx settings is performed using a discovery and authentication process through a port-channel interface on

the C9010.

The C9010 port-channel interface enabled for port extender (PE) communication consists of member ports configured with the cascade

port command. For more information, see the Provisioning a Port Extender section.

Provisioning a Port Extender

You can provision an N20xx system with an initial software configuration before or after you install and power on the PE. To provision an

N20xx system, start from the C9010 console and enter the following commands. If you enter the commands before you install the N20xx

system with a parent C9010, the preconfigured software settings download to the N20xx system when you attach it to a C9010 port and

power it up.

NOTE:

Although you can provision an N20xx system after you install and power it on, Dell Networking recommends

preconfiguring the software provisioning before you install it. Then connect the N20xx system to a preconfigured, cascaded

C9010 port. In this way, you can "plug and play" an N20xx system with a parent C9010.

Turn on the port-extender feature on a C9010.

CONFIGURATION mode

Dell(conf)# feature extended-bridge

Enter the Port-Extender configuration mode.

CONFIGURATION mode

Dell(conf)# pe provision pe-id

•

pe-id is a PE ID number from 0 to 255. Enter a pe-id value.

(Optional) Provision an N20xx system for PE stacking.

PORT-EXTENDER CONFIGURATION mode

Dell(conf-pe-0)# stack-unit unit-id type unit-type

•

unit-id is a stack-unit ID number from 0 to 7. The default value is 0.

•

unit-type is a stack-unit type.

Provisioning an N20xx system automatically creates a link aggregation group (LAG) on the C9010. The C9010 LAG member ports are

the cascade ports configured for the PE with the cascade interface command. The cascade ports must be operationally up

(no shutdown command) and have a default port configuration with no L2 and L3 configuration. The port interfaces must be the

same type. You can configure up to eight C9010 ports in the auto-LAG. The generated auto-LAG number is from 257 to 513.

All manuals and user guides at all-guides.com

Starting and Configuring the N20xx Switch