Dell N20 Series Kurulum Kılavuzu - Sayfa 43

Anahtar Dell N20 Series için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Dell N20 Series 48 sayfaları.

Sayfayı Yazdır

The setup wizard configures the initial values. After completing the wizard, the switch is configured as follows:

•

SNMPv2 is enabled and the community string is set up. SNMPv3 is disabled by default.

•

The admin user account is set up as defined.

•

A network management system is configured. From the management station, you can access the SNMP, HTTP, and CLI interfaces.

You may also choose to allow all IP addresses to access these management interfaces by choosing the (0.0.0.0) IP address.

•

DHCP is enabled on the OOB management interface.

•

An IP address is configured for the VLAN 1 routing interface.

•

A default gateway address is configured.

NOTE:

In the following example, the possible user options or default values are enclosed in [ ]. If you press Enter without

defining options, the default value is accepted. Help text is in parentheses.

Dell Easy Setup Wizard Console Example

The following example contains the sequence of prompts and responses associated with running a Dell Easy Setup Wizard session, using

the input values listed previously.

After the switch completes the POST and is booted, the following dialog appears:

Unit 1 - Waiting to select management unit)>

Applying Global configuration, please wait...

Welcome to Dell Easy Setup Wizard

The Setup Wizard guides you through the initial switch

configuration, and gets you up and running as quickly

as possible. You can skip the setup wizard, and enter

CLI mode to manually configure the switch. You must

respond to the next question to run the setup wizard

within 60 seconds, otherwise the system will continue

with normal operation using the default system

configuration. Note: You can exit the setup wizard at

any point by entering [ctrl+z].

Would you like to run the setup wizard (you must

answer this question within 60 seconds)? [Y/N] y

Step 1:

The system is not set up for SNMP management by

default. To manage the switch using SNMP (required for

Dell Network Manager) you can

. Set up the initial SNMP version 2 account now.

. Return later and set up other SNMP accounts. (For

more information on setting up an SNMP version 1 or

3 account, see the user documentation).

Would you like to set up the SNMP management interface

now? [Y/N] y

To set up the SNMP management account you must specify

the management system IP address and the "community

string" or password that the particular management

system uses to access the switch. The wizard

automatically assigns the highest access level

[Privilege Level 15] to this account. You can use Dell

Network Manager or other management interfaces to

change this setting, and to add additional management

system information later. For more information on

adding management systems, see the user documentation.

To add a management station:

All manuals and user guides at all-guides.com

Starting and Configuring the N30xx System