Dell PowerConnect 2708 Ekler - Sayfa 12

Anahtar Dell PowerConnect 2708 için çevrimiçi göz atın veya pdf Ekler indirin. Dell PowerConnect 2708 14 sayfaları. Enabling web-managed mode
Ayrıca Dell PowerConnect 2708 için: Veri Sayfası (12 sayfalar)

Sayfayı Yazdır

The common prioritization mechanisms implemented in the PowerConnect device are Class of

Service (CoS), according to IEEE802.1p, and DSCP (DiffServe Code Point) for IP traffic. CoS

reduces flow complexity by mapping multiple flows into eight classes of service. These classes

are set in the VPT (VLAN Priority Tag) 4-byte field tag, added to the packet by either a station

or networking device. The device provides mapping of CoS classes to 4 priority queues per port

(values are 1 to 4, where 1 is the lowest value, and 4 is the highest). For untagged packets service

priority class can be assigned per port. The service class value in the VPT always overrides the

service priority class defined per port.

DSCP provides a method of prioritizing IP packets, and indicates the service level desired in the

network. Incoming IP packets arrive with a DSCP value and are mapped to four priority queues,

based on the priority DSCP value assigned to them. The values are 1 to 4, where 1 is the lowest

value and 4 is the highest.

Via the CoS Setting screen, the user can assign priority to untagged packets through configuring

the ports ports. This screen contains fields for enabling or disabling CoS.

The CoS global parameters are configured via the CoS Settings screen. The Trust Mode relies on

predefined fields within the packet that determine the egress queue. The possible values for Trust

Mode are None (traffic is mapped to best effort queue q2), CoS (default value), and DSCP.

In the following example, for the configured Interface Port 5, the Trust Mode is configured as CoS

(determined by IEEE802.1p) —this is the Trust Mode default value. Disable "Trust" Mode on

Interface is checked— this setting overrides the Trust Mode on the Ethernet globally.

Figure 9-12. CoS Settings

Mapping CoS Values to Queues

In the following screen, CoS values are mapped to an egress queue. CoS priority tag values are zero

as the lowest, and 7 as the highest. There are four traffic priority queues supported .