Dell PowerConnect 2808 Sürüm Notları - Sayfa 4
Anahtar Dell PowerConnect 2808 için çevrimiçi göz atın veya pdf Sürüm Notları indirin. Dell PowerConnect 2808 6 sayfaları. Powerconnect 2800 series
Ayrıca Dell PowerConnect 2808 için: Hızlı Kılavuz (2 sayfalar)
Sayfayı Yazdır
From version 1.0.0.44 the following functionality was modified:
Title
Transitioning Between
Modes
Issues resolved
The following issues have been resolved in current firmware release
Description
Dell0000816 - MIB compilation when using
some MIB compilers.
Dell0000818 – Chassis Service Tag
Known Restrictions and Limitations
Title
MIB compilation using
"snmptranslate" tool
System Firmware Version 1.0.0.45
PowerConnect 2808/2816/2824/2848
Description
Change the functionality when device is transited between modes.
•
The current running configuration is automatically saved to local storage. If the
system is switched to unmanaged mode via the Managed Mode button, the
system does not load the saved configuration, but it is still maintained in the
device's local storage mode
•
On PC2616/PC2624/2648 - A transition from Unmanaged or Secure mode to
Managed mode via the use of the Managed Mode button results in the switch
resetting automatically and returning to Managed mode while running the saved
configuration (if no configuration exists, then the default configuration is used).
•
On PC2808 Only, Transition from Unmanaged to Managed mode behaves
differently – after mode button is pressed device is automatically configured
with IP address 192.168.2.1 and username admin (no password). User must
connect to the device and select, via Restore Configuration WEBUI page, if
device should return to previously saved configuration, or to default
configuration, or configuration loaded via TFTP. Only after this selection the
device will reboot to managed mode with the chosen configuration.
User Impact
Compilation errors while
using some MIB compilers
(for example., snmptranslate
tool)
MIB – Switch reports the
Switch Service Tag as
Chassis Service Tag.
However the device is not
designed to be included in a
chassis
Description
When using some MIB compilers (for example "snmptranslate" tool)
the following errors still exists:
Undefined OBJECT-GROUP (udpHCGroup): At line 486 in ./udp-
mib.mib
Undefined OBJECT-GROUP (dnsServZoneGroup): At line 1072 in
./rfc1611.mib
Subject to Change Without Notice
Release Notes
Resolution
Updated MIB files fixed this issue
partially. See "Known Restrictions
and Limitations" section for minor
issues still unresolved. Updated MIB
files are part of this official release.
Chassis Service Tag is now set to
NULL for PC28xx series switches.
ID
Dell0000816
Page 2