Dell PowerConnect BI-RX-4 Başlangıç Kılavuzu - Sayfa 22
Anahtar Dell PowerConnect BI-RX-4 için çevrimiçi göz atın veya pdf Başlangıç Kılavuzu indirin. Dell PowerConnect BI-RX-4 32 sayfaları. Powerconnect b-rx series
Sayfayı Yazdır
1
Power supply
FIGURE 13
Installing a power supply in a PowerConnect B-RX Series 16-slot chassis
6. For information about connecting power to the chassis, refer to
"Connecting DC power"
Connecting AC power
AC power is supplied through an AC power cord that is installed at the rear of the PowerConnect B-RX Series chassis.
1. Locate the power receptacle on the rear of the chassis, behind where AC power supplies are installed.
2. Lift the cord-retainer and connect a Dell-supplied AC power cord to the power supply.
3. Snap the cord-retainer over the power plug to hold it in place.
DANGER
If the installation requires a different power cord than the one supplied with the device, make sure you
use a power cord displaying the mark of the safety agency that defines the regulations for power cords in
your country. The mark is your assurance that the power cord can be used safely with the device.
4. For information about powering on the system, refer to
22
1
2
2
Release latch
on page 23.
"Connecting AC power"
"Powering-on the power source"
PowerConnect B-RX Series Getting Started Guide
on page 22 or
on page 25.
53-1001682-03