Dell PowerConnect BI-RX-8 Başlangıç Kılavuzu - Sayfa 26
Anahtar Dell PowerConnect BI-RX-8 için çevrimiçi göz atın veya pdf Başlangıç Kılavuzu indirin. Dell PowerConnect BI-RX-8 32 sayfaları. Powerconnect b-rx series
Sayfayı Yazdır
2. If your power source is AC, attach one end of a Dell-supplied AC power cord to the AC power supply as described
in
"Connecting AC power"
Insert the other end into a 115V or 120V wall outlet. Repeat this step for each installed AC power supply.
DANGER
If the installation requires a different power cord than the one supplied with the device, make sure you
use a power cord displaying the mark of the safety agency that defines the regulations for power cords in
your country. The mark is your assurance that the power cord can be used safely with the device.
CAUTION
If the wall outlet is not rated 115/120V and 20A, you must have an electrician rewire the outlet and
power source. Make sure you obtain a power cord displaying the mark of the safety agency that defines
the regulations for power cords in your country. The mark is your assurance that the power cord can be
used safely with the device.
NOTE
The PowerConnect B-RX Series switch is designed to provide uninterrupted service even when you insert or
remove the management modules and the interface modules. Therefore, the system does not have a separate
on/off power switch. To turn the system off, simply unplug the power cords.
NOTE
The wall outlet should be installed near the equipment and should be easily accessible.
3. If you are supplying a DC power source to a PowerConnect B-RX Series chassis, attach the power cables to the
DC power supply as described in
Connect the other end of the cables to the DC power source. Repeat this step for each installed DC power
supply. Then switch on the power source.
4. Verify that the PowerConnect B-RX Series switch has initialized successfully. For information, refer to
proper operation"
on page 26.
Verifying proper operation
To verify the proper operation of the PowerConnect B-RX Series chassis after power on, you can do the following:
•
Observe the LEDs
•
Display the status of the modules using the CLI
Observing the LEDs
After a PowerConnect B-RX Series chassis powers on, you can observe its LEDs to verify that it initialized
successfully. Refer to your hardware installation guide for a complete description of the LEDs.
If a problem persists after taking action described in this table, contact technical support.
26
on page 22.
"Connecting DC power"
on page 23.
PowerConnect B-RX Series Getting Started Guide
"Verifying
53-1001682-03