Dell PowerEdge M IO Aggregator Başlangıç Kılavuzu - Sayfa 29

Anahtar Dell PowerEdge M IO Aggregator için çevrimiçi göz atın veya pdf Başlangıç Kılavuzu indirin. Dell PowerEdge M IO Aggregator 38 sayfaları. Dell poweredge m i/o aggregator getting started guide

Sayfayı Yazdır

1. Internal Ports

Assembling a Switch Stack

After you complete the initial configuration, the Aggregator is powered up

and operational. Stacking is supported only on the 40GbE ports on the base

module.

Stacking is limited to two Aggregators in the same chassis in a single stack. Up

to three stacks are supported in an M1000e chassis. To configure a switch

stack, you must use the CLI.

Cabling the Switch Stack

Figure 1-9 shows a stacking example using two Aggregators in a chassis. The

Aggregators are connected to operate as a single stack in a ring topology using

only the 40GbE ports on the base modules. You can use the 40GbE ports on

the base module to create a stack in either a ring or daisy-chain topology.

Prerequisite: Before you attach the stacking cables, all Aggregators in the

stack must be powered up with the default or reconfigured settings as

described in "Reconfiguring Default Settings" on page 21.

Assembling a Switch Stack