Dell PowerEdge M420 Kullanıcı Kılavuzu - Sayfa 24

Anahtar Dell PowerEdge M420 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Dell PowerEdge M420 26 sayfaları. Dell poweredge blade servers getting started guide
Ayrıca Dell PowerEdge M420 için: Bilgi Güncellemesi (38 sayfalar), Sürüm Notları (27 sayfalar), Manuel (25 sayfalar), Kullanıcı Kılavuzu (23 sayfalar), Önemli Bilgiler Kılavuzu (35 sayfalar), Güncelleme Kılavuzu (32 sayfalar), Güncelleme Kılavuzu (28 sayfalar), Kullanıcı Kılavuzu (22 sayfalar), Başlangıç Kılavuzu (12 sayfalar), Manuel (38 sayfalar), Teknik Kılavuz (46 sayfalar), Teknik Kılavuz (48 sayfalar), Portföy Kılavuzu (27 sayfalar), Başlangıç Kılavuzu (14 sayfalar), Başlangıç Kılavuzu (12 sayfalar)

Rev 1.00

# exit

Step 5. Power cycle the 10GbE PTM for the firmware to take effect. From the CMC command

line type the following command:

$ racadm chassisaction -m switch-<n> powercycle

Step 6. Wait for 20 seconds, and then connect to the 10GbE PTM. Run:

$ connect switch-<n>

Step 7. Login to the 10GbE PTM command line interface as admin. Run:

# login admin

Step 8. To confirm that all three PhyX chips have the same firmware version, run the command:

& show image ver

Software image version: 1.0.28-201005131448-62

Component #1 FW version: 8.2.958

Component #2 FW version: 8.2.958

Component #3 FW version: 8.2.958

4.3.2 Updating Firmware for a Single PhyX Device

Step 1. Connect to the 10GbE PTM. Run:

$ Connect switch-<n>

Where n is the number of the switch, 2 in our example.

Step 2. To start the upgrade process for a single PhyX device (1,2, or 3), run the command:

# copy image from-file [device number]

The system is now waiting for the file to be transferred from the SSH client.

To complete the procedure, please follow Step 3 through Step 8 as described in

Software User's Manual

Section 4.3.1

above.