Allied Telesis AR740 RPS Hızlı Kurulum Kılavuzu - Sayfa 7
Güç Kaynağı Allied Telesis AR740 RPS için çevrimiçi göz atın veya pdf Hızlı Kurulum Kılavuzu indirin. Allied Telesis AR740 RPS 13 sayfaları. Ar700 series router
Ayrıca Allied Telesis AR740 RPS için: Hızlı Kurulum Kılavuzu (6 sayfalar)
Sayfayı Yazdır
Quick Install Guide
Figure 2: DC Power inlet terminals on an AR740.
FOR CENTRALIZED DC
POWER CONNECTION,
INSTALL ONLY IN A
RESTRICTED AREA
38-75VDC
Software Release 2.6.1
C613-04027-01 REV E
DC Power
, 2A
Power inlet
The System LED should flash for approximately 10 seconds as the router
runs internal tests. If the LED continues to flash or remains lit, refer to the
AR Router Hardware Reference for troubleshooting information.
DC models do not have RPS connectors.
10. Connect the data cables
Make sure each cable connection is secure.
11. Initiate router start-up
Using the terminal cable supplied, connect a VT100-compatible terminal,
or the COM port of a PC running a terminal emulation program such as
Windows Terminal, to the console port (port 0) on the router's rear panel.
Set the communication parameters on your terminal or terminal emulation
program to:
•
Baud rate: 9600
•
Data bits: 8
•
Parity: None
•
Stop bits: 1
•
Flow control: Hardware
See the AR Router Hardware Reference for more information on configuring
emulation software.
12. Log in and set password
The log-in prompt appears on the terminal or PC. If the log-in prompt
doesn't appear, press [Enter] two or three times.
When the router boots for the first time, it automatically creates an account
with manager privileges. The account has the log-in name "manager" and
the password is "friend".
At the log-in prompt, enter the log-in name and password.
Login: manager
Password: friend
The router's command prompt appears and you can now configure the
router using the command line interface.
3
3
Tx
1
Rx
0
SYN
7
3