Dell PowerEdge M520 Manuel - Sayfa 16

Anahtar Dell PowerEdge M520 için çevrimiçi göz atın veya pdf Manuel indirin. Dell PowerEdge M520 25 sayfaları. Dell poweredge blade servers getting started guide
Ayrıca Dell PowerEdge M520 için: Bilgi Güncellemesi (38 sayfalar), Sürüm Notları (27 sayfalar), Kullanıcı Kılavuzu (23 sayfalar), Önemli Bilgiler Kılavuzu (35 sayfalar), Güncelleme Kılavuzu (32 sayfalar), Güncelleme Kılavuzu (28 sayfalar), Kullanıcı Kılavuzu (26 sayfalar), Kullanıcı Kılavuzu (22 sayfalar), Başlangıç Kılavuzu (12 sayfalar), Teknik Kılavuz (46 sayfalar), Teknik Kılavuz (45 sayfalar), Portföy Kılavuzu (27 sayfalar), Başlangıç Kılavuzu (14 sayfalar), Başlangıç Kılavuzu (12 sayfalar)

Rev 1.00

Description:

Use this command to restart the module components. When this command is issued, PTM compo-

nents go through a full hardware reset, followed by software reload.

Options:

• device_number: specify a single device to reset

Example:

$ reload

3.5

Software Update Commands

Synopsys:

show image ver

Description:

Display the current software image version.

ADMIN: This command also displays the firmware version of each component.

Example:

# login admin

& show image ver

Software image short version: V Z.ZZ

Software image version: X.X.XXX-<date stamp>

Component #1 firmware version: Y.Y.YYY

Component #2 firmware version: Y.Y.YYY

Component #3 firmware version: Y.Y.YYY

& login user

Synopsys:

copy image from-file [device_number]

Description:

Update the firmware the PTM software image. In ADMIN mode, it allows selective upgrade of a

single device in the PTM. Immediately after running this command, the CLI waits for the user to

send the firmware image using the ZModem protocol. To abort this operation, use CTRL-C. For

additional details on the firmware update procedure refer to

on page 22

ADMIN:

Section 4, "Operating Procedures,"

Software User's Manual