Dell PowerEdge M520 Kullanıcı Kılavuzu - Sayfa 21

Anahtar Dell PowerEdge M520 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Dell PowerEdge M520 26 sayfaları. Dell poweredge blade servers getting started guide
Ayrıca Dell PowerEdge M520 için: Bilgi Güncellemesi (38 sayfalar), Sürüm Notları (27 sayfalar), Manuel (25 sayfalar), Kullanıcı Kılavuzu (23 sayfalar), Önemli Bilgiler Kılavuzu (35 sayfalar), Güncelleme Kılavuzu (32 sayfalar), Güncelleme Kılavuzu (28 sayfalar), Kullanıcı Kılavuzu (22 sayfalar), Başlangıç Kılavuzu (12 sayfalar), Teknik Kılavuz (46 sayfalar), Teknik Kılavuz (45 sayfalar), Portföy Kılavuzu (27 sayfalar), Başlangıç Kılavuzu (14 sayfalar), Başlangıç Kılavuzu (12 sayfalar)

Dell 10Gb Ethernet Pass Through II

Step 10.Login to the 10GbE PTM CLI as admin. Run:

# login admin

Step 11.To confirm that all PhyX® chips have the same firmware version, run the command:

& show image ver

Software image version: X.X.XXX-<date stamp>

Component #1 FW version: Y.Y.YYY

Component #2 FW version: Y.Y.YYY

Component #3 FW version: Y.Y.YYY

4.2

CPU Software Update

This procedure describes how to update CPU SW using a .bin binary file.

Step 1. Connect to the 10GbE PTM using an SSH Client as described in

the 10GbE PTM CLI," on page

Step 2. From the CMC command line, enter the following command:

$ racadm chassisaction -m [10GbE PTM device Name] powercycle

Example according to section 2 output:

$ racadm chassisaction -m switch-2 powercycle

Note You must connect before the 15-second countdown expires in order to interrupt

Step 3. Connect to the 10GbE PTM CLI. Enter:

$ connect switch-<n>

Where <n> is the number of the switch, 2 in our example.

Note Press any key before the 15-second countdown expires in order to get to the boot

You should see the banner "Welcome to Dell PTM Boot loader console". Note that the

banner displays the current CPU FW build. If you do not succeed, then you need to exit

the 10GbE PTM CLI (enter "exit"), and then go back to Step 1 of this section.

Step 4. From the Boot loader command line, run:

# cpufwupdate

the Boot Loader.

loader command line.

Rev 1.00

Section 2, "Connecting to