Dell PowerEdge M820 Systems Kullanıcı Kılavuzu - Sayfa 9

Anahtar Dell PowerEdge M820 Systems için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Dell PowerEdge M820 Systems 22 sayfaları. Dell poweredge blade servers getting started guide
Ayrıca Dell PowerEdge M820 Systems için: Bilgi Güncellemesi (38 sayfalar), Sürüm Notları (27 sayfalar), Kullanıcı Kılavuzu (23 sayfalar), Önemli Bilgiler Kılavuzu (35 sayfalar), Güncelleme Kılavuzu (32 sayfalar), Güncelleme Kılavuzu (28 sayfalar), Kullanıcı Kılavuzu (26 sayfalar), Başlangıç Kılavuzu (12 sayfalar), Kullanıcı El Kitabı (3 sayfalar), Teknik Kılavuz (46 sayfalar), Portföy Kılavuzu (27 sayfalar), Başlangıç Kılavuzu (14 sayfalar), Başlangıç Kılavuzu (12 sayfalar), Teknik Kılavuz (47 sayfalar)

Dell -10GbE PTM

The PTM supports hot-insertion into the chassis. If the PTM is inserted to a powered chassis, the

power LED (green) should turn on immediately.

2.2.2 PTM Removal

The PTM supports hot-removal. It may be removed when the chassis is powered on or off.

The PTM must not be removed during a firmware update process.

Note: Firmware update is in progress when the amber LED is blinking.

2.3

The PTM front panel presents 16 SFP+ ports. Each port provides connectivity to a server with the

respective number. Figure 4 shows the front panel view of the PTM.

10 Gb Ethernet Pass Through II

The PTM supports SFP+ modules for 10 Gigabit Ethernet, with 10GBASE-SR and 10GBASE-LR

PHYs. SFP+ modules must be approved for use with this PTM. Modules not approved may not

work. See Supported Optical Modules and DCAs on page 17 for lists of approved DCAs and opti-

cal modules.

Optical transceiver modules have a locking mechanism which can be opened or closed.

To insert the module into the cage:

1. Open the module's locking mechanism.

2. Make sure that the male connectors on the module aligns with the female connector inside of

the cage. Also check that there is no dirt or foreign matter in the module or in the cage.

3. Insert the module into the adapter card module cage.

4. Close the locking Mechanism.

To remove the module from the cage:

1. Unlock the locking mechanism by opening the handle.

2. Pull the module out of the cage.

Figure 4: Pass Through II Front Panel

Rev 1.0