Dell S4048-ON Yapılandırma Kılavuzu - Sayfa 6

Anahtar Dell S4048-ON için çevrimiçi göz atın veya pdf Yapılandırma Kılavuzu indirin. Dell S4048-ON 30 sayfaları. Enterprise switches
Ayrıca Dell S4048-ON için: Yapılandırma Kılavuzu (19 sayfalar), Sorun Giderme Kılavuzu (29 sayfalar)

Sayfayı Yazdır

Introduction

This document illustrates how to configure Dell EMC™ Networking S4048-ON switches for use with Dell™ PS

Series storage while using Dell EMC best practices. The recommended configuration uses Link Aggregation

Groups (LAGs) for inter-switch connections.

The host servers and storage controllers can be connected to the switches using the 40GbE Quad Small

Form-factor Pluggable (QSFP) ports with appropriate breakout cables. The switches are interconnected to

each other using 40GbE cables.

To enable Data Center Bridging (optional), see section 2.2 (OS 9.x) or 3.2 (OS 10.x).

If you are following the Rapid EqualLogic Configuration steps at

http://en.community.Dell.com/techcenter/storage/w/wiki/3615.rapid-equallogic-configuration-portal-by-

sis.aspx, use sections 1 and 2, or 1 and 3 in this Switch Configuration Guide.

Note: For more information on PS Series SAN design recommendations, see the

Configuration

1.1

Firmware support

The Dell EMC Networking S4048-ON Open Networking switch has the ability to run different switch operating

systems software/firmware. This document provides configuration steps specific to Dell Networking OS 9.x

(firmware 9.x) and Dell Networking OS 10.x (firmware 10.x). Refer the section of this document that is

applicable to your firmware version:

•

Dell Networking OS 9.x (firmware 9.x): section 2

•

Dell Networking OS 10.x (firmware 10.x): section 3

1.2

Document conventions

Table 1 lists the formatting conventions used in this document.

Item

Code samples

Parameters

Command-line commands

Command-line user-supplied

variables

1.3

Audience

This switch configuration guide describes an optimal configuration following Dell EMC best practices for a PS

Series iSCSI SAN and is intended for storage or network administrators and deployment personnel.

Dell EMC Networking S4048-ON Switch Configuration Guide for Dell PS Series SANs | SCG1026

Guide.

Document conventions

Convention

Monospace

Italic

Bold

Bold, italic, brackets <vlan-id>

Example

System configuration has been modified.

Dell(profile-name)#

OS#show version

Dell PS Series