Dell S6000-ON Kurulum Kılavuzu - Sayfa 33

Anahtar Dell S6000-ON için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Dell S6000-ON 41 sayfaları. Open networking
Ayrıca Dell S6000-ON için: Başlangıç Kılavuzu (26 sayfalar), Sorun Giderme Kılavuzu (29 sayfalar)

Sayfayı Yazdır

ONIE: Rescue

Starts ONIE without ONIE Discovery Service

Useful for running Diagnostics manually

ONIE: Uninstall OS

Restore to factory defaults erases any installed OS

ONIE: Update ONIE

For downloading and updating ONIE from a URL

ONIE: Embed ONIE

For downloading and updating ONIE from a URL and erases any installed OS

ONIE: Diag ONIE

Run Diagnostic package for S6000-ON

During initial setup, the system boots to ONIE Install. ONIE Install boots with ONIE Discovery to the console—ONIE:.

ONIE Service Discovery on the S6000–ON System

ONIE attempts to locate the installer through a number of discovery methods, as shown. To download and run an installer, the ONIE

Service Discovery feature uses the first successful method found.

Passed from the boot loader.

Search locally attached storage devices for one of the ONIE default installer filenames (for example, USB).

Exact the URLs from DHCPv4.

Inexact URLs based on DHCPv4 responses.

Query to IPv6 link-local neighbors using HTTP for an installer.

TFTP waterfall — from DHCPv4 option 66

Example of the ONIE ifconfig eth0 Command

Example of the ONIE ifconfig eth0 <ip address> Command

If none of the ONIE Service Discovery methods are successful, you can disable is using the onie-discovery-stop command.

You can install an operating system manually from HTTP, FTP, or TFTP using the onie-nos-install <URL> command.

The ONIE Install environment uses DHCP to assign an IP address to the management interface (eth0). If that fails, it uses the default IP

address 192.168.3.10/255.255.255.0.

To display the IP address, use the ifconfig eth0 command.

ONIE:/ # ifconfig eth0

eth0 Link encap:Ethernet HWaddr 90:B1:1C:F4:9C:76

inet addr:10.11.53.33 Bcast:10.255.255.255 Mask:255.0.0.0

inet6 addr: fe80::92b1:1cff:fef4:9c76/64 Scope:Link

UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1

RX packets:18 errors:0 dropped:0 overruns:0 frame:0

TX packets:24 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000

RX bytes:1152 (1.1 KiB) TX bytes:6864 (6.7 KiB)

Interrupt:21 Memory:ff300000-ff320000

To assign an IP address to the management interface (eth0) and verify the network connectivity, use the ifconfig eth0 <ip

address> command.

ONIE:/ # ifconfig eth0 10.11.53.33/16

Verify the network connection with ping.

ONIE:/ # ping 10.11.8.12

PING 10.11.8.12 (10.11.8.12): 56 data bytes

64 bytes from 10.11.8.12: seq=0 ttl=62 time=1.357 ms

64 bytes from 10.11.8.12: seq=1 ttl=62 time=0.577 ms

Management ports