Dell 540s - Studio Slim Desktop Pc Servis Kılavuzu - Sayfa 5

Yazıcı Dell 540s - Studio Slim Desktop Pc için çevrimiçi göz atın veya pdf Servis Kılavuzu indirin. Dell 540s - Studio Slim Desktop Pc 38 sayfaları. Service manual

Sayfayı Yazdır

Back to Contents Page

Replacing the Rubber Foot

Dell Studio™ Slim 540s Service Manual

Replacing the Rubber Foot on the Side of Your Computer

Replacing the Rubber Foot on the Bottom of Your Computer

CAUTION:

Before working inside your computer, read the safety information that shipped with your computer. For additional safety best

practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.

Replacing the Rubber Foot on the Side of Your Computer

1. Follow the procedures in

Before You

2. Place your computer upright with the computer cover facing the side.

3. Pull the rubber foot away from the chassis until it is released.

NOTE:

If you are installing a new rubber foot, remove the double-sided glue attached to the rubber foot.

4. To replace the rubber foot, align and press the rubber foot into the rubber foot slot in the chassis.

5. Align and press the rubber foot pin into the hole in the rubber foot.

rubber foot slot

rubber foot pin

Replacing the Rubber Foot on the Bottom of Your Computer

1. Follow the procedures in

Before You

2. Lay your computer on its side with the computer cover facing up.

3. Pull the rubber foot and pull it away from the chassis until it is released.

NOTE:

If you are installing a new rubber foot, remove the double-sided glue attached to the rubber foot.

4. To replace the rubber foot, align and press the rubber foot onto the rubber foot recess in the chassis.

Begin.

rubber foot

Begin.