EarthQuake Cinenova 7 Kullanıcı Kılavuzu - Sayfa 17
Amplifikatör EarthQuake Cinenova 7 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. EarthQuake Cinenova 7 20 sayfaları.
Sayfayı Yazdır
Cinénova 7 Power Amplifiers
Getting Started with the Cinénova 7
Confirm the voltage setting of the amplifier. It must match the voltage in your
home. The amp is set by factory to either 120V or 240V. Check above the
circuit breaker for this information.
Amplification Block Plate
1
2
www.earthquakesound.com
Power Plate
1) INPUT SELECTION
Set the input control to either RCA or XLR.
This tells the amp which input type will be
used.
3) 12VDC
3
4
2) SPEAKER CONNECTIONS
4) PLUG IN POWER CORD
WHEN APPLICABLE
If you plan to power the
Cinénova using an
external source, then
you will need to plug the
source into the 12VDC
Trigger.
When using this feature
the main power switch
must remain in the OFF
position at all times.
The fuse holder is located directly under the power
socket. It contains one extra 15 ampere, 250V fuse.
To access the fuse holder, make sure your
Cinénova is turned off and unplugged from both the
wall outlet and the amplifier's power socket. Place a
flat head screwdriver in the groove on the top of the
fuse holder and simply pry off the fuse holder.
Cinénova 7 Pre-Setup
A pair of binding posts is
p r o v i d e d f o r e a c h
channel. These posts
accept bare wire, spade
lugs & banana type
plugs. If bare wire is
u s e d t h e n , s t r i p
approximately 1/2 inch
to 3/4 inch of insulation
from the end of each
wire and carefully twist
the strands of each
conductor together.
Then insert.
Plug the AC power cord
into the amp first then
into the wall outlet.
Make sure it is firmly
connected.
17