EarthQuake 9800 Series Operatör El Kitabı - Sayfa 11
Çim ve Bahçe Ekipmanları EarthQuake 9800 Series için çevrimiçi göz atın veya pdf Operatör El Kitabı indirin. EarthQuake 9800 Series 16 sayfaları. Two-man earth auger powerhead
Ayrıca EarthQuake 9800 Series için: Operatör El Kitabı (13 sayfalar), Operatör El Kitabı (19 sayfalar), Operatör El Kitabı (20 sayfalar)
Sayfayı Yazdır
TROUBLESHOOTING GUIDE
PROBLEM
Engine will not start
Engine runs rough, floods during
operation
Engine is hard to start
Engine misses or lacks power
Auger turns at idle
Auger turns, but has no power
Auger cuts slowly
Engine runs, then quits
Check for parts online at www.getearthquake.com or call 800-345-6007 M-F 8-5
POSSIBLE CAUSE
1. Power switch off
2. Spark plug wire disconnected
1. Dirty air cleaner
2. Carburetor out of adjustment
1. Stale fuel
2. Spark plug wire loose
3. Dirty carburetor
1. Clogged fuel tank
2. Clogged air cleaner
3. Improper carburetor adjustment
4. Spark plug dirty, improper gap, or wrong
type
1. Idle speed too high
2. broken clutch spring
1. Carburetor out of adjustment
2. broken transmission
3. Worn clutch shoes
4. Worn engine lower seal
1. Damaged point
2. Worn out blade
1. Screen in carburetor plugged
Two-Person Earth Auger Powerhead 9800 Series
CAUTION
PRACTICE SAFETy AT ALL TIMES. ENGINE MUST BE
TURNED OFF AND ALLOWED TO COOL, AND SPARk
PLUG WIRE MUST BE DISCONNEC TED BEFORE
ATTEMPTING ANy MAINTENANCE OR REPAIR.
REMEDy/ACTION
1. Flip switch to ON position
2. Connect spark plug wire to spark plug
1. Clean or replace air cleaner
2. Take to authorized briggs & Stratton/Honda
service center
1. Drain old fuel and replace with fresh. Use gas stabi-
lizer at end of season
2. Make sure spark wire is securely attached to spark
plug
3. Clean carburetor, use gas stabilizer, new gas can
1. Remove and clean
2. Clean or replace
3. Take to authorized briggs & Stratton/Honda service
center
4. Replace spark plug and adjust gap
1. Adjust idle speed lower
2. Replace both springs
1. Take to authorized briggs & Stratton/Honda service
center
2. Replace transmission
3. Replace clutch shoes and springs
4. Take to authorized briggs & Stratton / Honda ser-
vice center
1. Replace fishtail point
2. Replace blade
1. Clean screen, use gas stabilizer, clean gas can
Operator's Manual
11