EarthWay 2170 Montaj ve Kullanım Talimatları Kılavuzu - Sayfa 2

Serpme EarthWay 2170 için çevrimiçi göz atın veya pdf Montaj ve Kullanım Talimatları Kılavuzu indirin. EarthWay 2170 6 sayfaları. Commercial broadcast spreader with side spread control
Ayrıca EarthWay 2170 için: Montaj ve Kullanım Talimatları Kılavuzu (8 sayfalar), Kullanım Talimatları Kılavuzu (8 sayfalar), Montaj Talimatları Kılavuzu (12 sayfalar), Montaj ve Kullanım Talimatları Kılavuzu (6 sayfalar), Montaj Talimatları Kılavuzu (10 sayfalar)

Install impeller onto pinion shaft. Insert 1/8" x 1-1/4" cotter pin

through impeller then through pinion shaft. Use hole nearest gear box.

Spread cotter pin to prevent from falling out. Next, install the Cross

Brace through the Gearbox Brace Support as shown above.

Install axle bearings to both lower

handles. NOTE: Notch on bearings and

lower handles. Bearings must go

through flat side of lower handle.

Install Lower Handles onto Axle to both sides as shown above. Now insert 1-1/2" bolt through first hole in lower handle, then through

frame brace, and finally into the threaded connector in the Cross Brace. [NOTE: Dimples on frame braces must be facing toward gearbox as

shown.] DO NOT TIGHTEN YET.

Next insert 1-1/2" bolt through other end of frame brace and through second hole in frame install locknut.

DO NOT TIGHTEN YET.

Now insert 2-1/4" bolt through second hole in lower handle and through first hole in frame..

NOW GO BACK AND TIGHTEN ALL NUTS AND BOLTS STARTING WITH FIRST STEP. DO NOT OVER TIGHTEN.

PAGE 2

Install Gearbox by inserting the pinion shaft into hole in

center of hoppers bottom. The word "FRONT" on the gearbox

must point to F

of the hopper.

RONT