EarthWay EV-N-SPRED C24HDS Montaj ve Kullanım Talimatları Kılavuzu - Sayfa 4
Serpme EarthWay EV-N-SPRED C24HDS için çevrimiçi göz atın veya pdf Montaj ve Kullanım Talimatları Kılavuzu indirin. EarthWay EV-N-SPRED C24HDS 10 sayfaları. Broadcast spreader
Ayrıca EarthWay EV-N-SPRED C24HDS için: Montaj ve Kullanım Talimatları Kılavuzu (9 sayfalar)
Sayfayı Yazdır
10. Install handle shaft to lower handles and pivot & bracket assembly as shown. Using (4)
1 ¾" bolts with cupped washers (C24HD) and (4) locknuts (2) cupped washers (C24HD).
[TIP: Attach right side first with cupped washers on both nuts and bolts, then attach left (Pivot
Bracket) side with washers only on the bolt side]
11. Install flattened end of control rod in to lever on gauge
into Control Rod Tabbed hole as shown. Turn to lock in
place.
NEXT: Install (1) 1/4-20 Hex Nut [not a locknut] on to
Control Rod and thread halfway as shown below.
and
n
Otice cupped wAsher lOcAtiOns
c24hd
fOr
1/4-20 x 1"
Hex Head Bolt
Stainless
15. Install the two 1/4-20 x 1" Stainless Steel bolts into holes located
on each side of the hopper and secure with 1/4-20 lock-nut. Next slide
Debris Screen under the two bolts inside the hopper.
PAGE 4
TIGHTEN BOLTS AND NUTS NOW.
¼-20 X 1¾"
Hex Head Bolt
¼-20
and
(Cupped Washer
Lock Nut
for C24HD)
(Cupped Washer
for C24HD)
Assembly
1/4-20 Lock Nut
Stainless
Setting #30
Insert Control Rod
into
Pivot Bracket
CALIBRATION POINT
Attach ¼-20 REGULAR
(NOT LOCKNUTS) Hex Nuts
at these points.
Notice the position
of the double bend point.
12. Next push lever forward to setting "0". Align control rod with hole
in pivot bracket, pull lever backward to insert control rod through
hole in pivot bracket. [TIP: If the lever does not move easily, loosen
slightly to make this step easier] Now install 1/4-20 regular nut on to
Control rod.
13. Pull lever back to setting "30" as shown. Next push pivot &
bracket forward so that the shut off plate in the hopper is in the full
open position. [NOTE: THE SETTING OF "30" ON THE GAUGE &
LEVER ASSEMBLY MUST OPEN THE SHUT-OFF COMPLETELY
FOR PROPER CALIBRATION.] Now tighten the nuts against the
pivot bracket to prevent change in calibration. Test by opening
and closing the Gauge & Lever a few times to ensure an accurate
calibration.
14. Tension on the flow control lever may be adjusted by tightening
or loosening the tension nut as shown above.
16. Insert Agitator to pinion shaft on inside of hopper.
NOTE: Position of flat side of agitator. This pin should
be installed as shown above.
Gauge & Lever
Lever Tensioning Nut
DO NOT TIGHTEN NUTS YET.
Control Rod
Tabbed Hole
Control Rod