EarthWay Flex-Select Hızlı Başlangıç Kılavuzu - Sayfa 2

Dış Mekan Arabası EarthWay Flex-Select için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. EarthWay Flex-Select 5 sayfaları.

How to ensure your spreader is properly calibrated

- continued

STANDARD-OUTPUT Tray: Make sure the drop holes in the bottom of the hopper are

#30

FULLY OPEN when the Rate Control handle is on #30. If the shut-off is not set correctly,

please adjust Control Rod at the Pivot to position the shut-off for FULLY OPEN hopper position

at #30 on the Rate Control Lever.

Calibration Adjustment

Review the Control Lever position to confirm that it is set so that the rear edge of the Lever is

resting at #30 (the stop) and the drop holes are open. If the shut-off is not properly positioned,

you will need to adjust the Control Rod at the Pivot Bracket shown below. TIP: If your shut-off

is not able to OPEN fully, loosen the bottom nut a few turns, then tighten the upper nut so that

it allows you to push the shut-off fully open. Next, tighten each nut so that they contact the

pivot bracket without moving it, and then carefully tighten each nut fully so they do not loosen

during use. Recheck adjustment as outlined above.

GAUGE &

LEVER

PIVOT

CALIBRATION

POINT

Control Lever Drag adjustment

If the Control Lever does not stay in position causing the setting rate to change without

Lever

your intervention, you can adjust the drag on the Lever by tightening or loosening the nut

shown to the right until the drag is appropriate.

Drag

Adjustment

If you have any questions regarding the operation or assembly of your spreader please call us at 800-294-0671 or 574-848-

7491 Monday - Friday 9:00am - 4:00pm Eastern, or visit www.earthway.com for more information