Allied wagner 591004 Kurulum Talimatları Kılavuzu - Sayfa 8

Dokunmatik ekran Allied wagner 591004 için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Allied wagner 591004 10 sayfaları. Vehicle monitor kit

Sayfayı Yazdır

Functional Test

1. Once established that the wiring is correct, turn

the keyswitch to the "OFF" position.

2. Plug the wire harnesses into the vehicle monitor.

3. Ensure that all connections are snug and secure.

4. Provided that you have contacted the Allied Sys-

tems Service Department and verified the vehicle

monitor has been activated, either work with your

account administrator or use your Near Me™ app

in conjunction with the following steps to verify that

the vehicle monitor is wired correctly and function-

ing as expected.

NOTE: lt is important that as many J 1939 faults as

possible are simulated to validate that the equipment

provides the alarms you would expect to see on the

Web Center Alarms screen when the faults occur. As

you move through the test of each fault, be sure that

the fault is displayed on the Alarm screen in Web Cen-

ter or on your NearMe™app.

5. Start the machine. Refer to your operator's manual

if necessary.

6. After the machine has been started, confirm that

the status LED's on the vehicle monitor are active.

Refer to Table 3 and Table 4 for LED status be-

havior and definitions.

7. Once the vehicle monitor is determined to be up

and running, wait 5 minutes and then check the

asset in Near Me™ or Web Center to see if it has

communicated successfully. If there's any issue,

contact the Allied Systems Service Department to

determine next steps.

8. If you can see the asset in NearMe™ (or Web

Center) confirm the following:

a. Vehicle monitor is communicating with the

Web Center

b. Equipment running status indicates that the

equipment is running

c. Battery voltage level displayed for the equip-

ment matches the expected equipment bat-

tery voltage level (24 VDC)

d. Confirm that the Map location appears to be

correct

NOTE: The vehicle monitor Low Battery Voltage alarm

threshold is set to 23.5 VDC. If it is necessary to have

the threshold adjusted otherwise, please contact the

Allied Systems Service Department.

9. After 5 to 10 minutes, check Near Me™ or Web

Center (for best results, use Google Chrome or

Mozilla Firefox browser for displaying tracking

data) and review the interval data that has been

received from the vehicle monitor to be sure the

data makes sense according to the conditions of

the run. You may need to refresh your Near Me™

view to be sure it is displaying the most current in-

formation that has been received from the vehicle

monitor.

10. Once the interval data has been reviewed, turn

the machine off.

11. After test data and communications are verified,

testing is complete.

12. Once equipment is off, record the equipment run

hours and contact the Allied Systems Service

Department to have them update the run hours on

the vehicle monitor. Please be sure the equipment

control panel is still on for this step in order for the

vehicle monitor to receive the run hours update

properly. Failure to do so will prevent the vehicle

monitor from being properly updated and equip-

ment run hours will be incorrect.

80-1056

Rev: 8-2014