Alligator KC9503/P-4 Kullanım Kılavuzu - Sayfa 2

Verici Alligator KC9503/P-4 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Alligator KC9503/P-4 2 sayfaları.

Sayfayı Yazdır
Specification
1.
Input Voltage:
2.
High-stability crystal oscillator
3.
Phase-lock loop control
4.
FM Stereo transmission
5.
Radio Frequency Range:
6.
Frequency Response: 150Hz to 20KHz
7.
Stereo separation:-25dB at 25cm
8.
Signal distortion: less than 5%
9.
Station Memory Preset:
10. Maximum receivable range:
Precautions
l
Avoid using the FM Transmitter with any devices simultaneously except the iPod, radio speaker system
or the dock, mobile adaptor for charging the iPod
l
Storage temperature should be less then 60 degrees
l
Please unplug FM Transmitter from iPod , Dock or mobile adaptor if you would plan to not use it for a
long time
l
Do not lay FMT on a surface that is slanted or unstable
NOTE:
Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
-
Reorient or relocate the receiving antenna.
-
Increase the separation between the equipment and receiver.
-
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-
Consult the dealer or an experienced radio/TV technician for help.
FCC ID: S4CKC9503
MADE IN CHINA
This device complies with part 15 of the FCC
Rules. Operation is subject to the following
two conditions: (1) this device may not cause
harmful interference, and (2) this device must
accept any interference received, including
interference that may cause undesired
operation.
Date: 22/11/2005
DC 3.3V 25mA
88.1MHz-107.9MHz
10 Channels
19.5 feet