Miele NOVOTRONIC W 1903 Kullanım Kılavuzu - Sayfa 40

Yıkayıcı Miele NOVOTRONIC W 1903 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Miele NOVOTRONIC W 1903 44 sayfaları. Miele washer user manual

Sayfayı Yazdır

Miele NOVOTRONIC W 1903 Kullanım Kılavuzu

Plumbing

Connect the water supply hose (the

hose marked blue) to the cold water

valve.

Turn on the valve and check for leaks.

The water pressure must be within 14-

140 psi (0.1-1 MPa). If the water press-

ure in greater than 140 psi (1 MPa), a

pressure reducer must be installed. At

pressures below 14 psi (0.1 MPa), the

standard inlet valve of the machine

must be exchanged for a low pressure

version available from the Miele Parts

Dept.

The water supply hose is equipped

with a filter; please do not remove this

filter.

Connection to the drain sys-

tem

The 1.5 m (5 ft.) drain hose may be con-

nected as follows:

1. Directly into a sink: hook the hose

over the edge of the sink and secure

it firmly(e.g. by tieing the hose to the

water faucet).

2. Connection to a stand pipe: place the

drain hose into a 38 mm (1

stand pipe and firmly secure it. (An

antisiphoning device is not re-

quired;there is one built into the ma-

chine.)

3. To a floor drain: if desired, the drain

hose may be extended to 4.5 m

(15 ft.) maximum.

The machine drains using a pump with

a maximum delivery head of 1 m (4 ft.).

Make sure there are no kinks in hose.

The machine is equipped with an air-

gap/anti-siphoning system so that no

minimum drain height is required.