Miele WS 5323 Kullanım Talimatları Kılavuzu - Sayfa 24
Yıkayıcı Miele WS 5323 için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Miele WS 5323 36 sayfaları.
Sayfayı Yazdır
Liquid dispensing
Commissioning the dispensing pumps
Before the liquid dispensing pumps can be
used the liquid detergent must be drawn into
the system and the amount to be dispensed
set. The Service Programme is used for this.
Drawing in the liquid detergent
Feed the suction pipes into the liquid deter-
gent containers.
Service operation:
Switch off the machine.
In operating mode B, turn the programme
selector switch to 24.
Switch on the machine, and within 4 sec-
onds, press the Block + T button 4 times
in quick succession. This brings you into
Service operation.
The cursor will be on the Service pro-
gramme.
SERVICE - OPERATION
>SERVICE PROGRAMMES<
After selection press Start button.
Press the Start X button.
SERVICE - OPERATION
SERVICE PROGRAMME >1<
After selection press Start button.
Press the Plus 4 button to select SER-
VICE PROGRAMME 2 and press the Start
X button.
SERVICE - OPERATION
SERVICE PROGRAMME 2
Dispenser valve >D1< Disp. time 0 Secs.
After selection press Start button.
Use the Plus 4 to select D1, use the 2
cursor button to move to the input field for
dispensing time and use the Plus 4 but-
ton to enter a dispensing time of approx.
20 secs. Press the Start X button and the
hoses for pump 1 will be filled.
M.-Nr. 05730940
MACHINE DATA
à
SERVICE PROGS
à
SERVICE PROGS
SERVICE - OPERATION
SERVICE PROGRAMME 2
Dispenser valve >D1< Disp. time 20 Secs.
Cancel with the End button.
Cancel with the End 7 button.
Repeat the whole process with D2 and D3.
SERVICE - OPERATION
>SERVICE PROGRAMMES<
After selection press Start button.
Press the Start X button, select SERVICE
PROGRAMME 2 and press the Start X
button.
To exit from Service operation:
Cancel with the End 7 button and switch
off the machine.
Switch the machine on and select Pro-
gramme 8 SEPARATE RINSE and SPIN
to flush the liquid agent out of the machine.
To correct the amount dispensed by the
pumps
(should the dispensing times set not be long
enough)
The amount to be dispensed is measured out
in litres in the Service programme. The proce-
dure is similar to the one for drawing up the
liquid detergent. The dispensing time decided
on is then set in the Operating mode C Pro-
gramming in the step programming.
The maximum pump throughput is approx.
168 ml/min. for all pumps.
These figures are only intended as a guide
and will vary according to the medium.
Feed the suction pipe into a deep measur-
ing container with sufficient liquid deter-
gent and keep it at the full level.
Continue as for Drawing in liquid deter-
gent.
24
SERVICE PROGS
MACHINE DATA
à