Miele DA 3160 EXT Çalıştırma ve Kurulum Talimatları - Sayfa 15
Havalandırma Davlumbazı Miele DA 3160 EXT için çevrimiçi göz atın veya pdf Çalıştırma ve Kurulum Talimatları indirin. Miele DA 3160 EXT 40 sayfaları. Cooker hoods
Ayrıca Miele DA 3160 EXT için: Çalıştırma ve Kurulum Talimatları (40 sayfalar), Çalıştırma ve Kurulum Talimatları (40 sayfalar)
A range of Miele branded cleaning and
conditioning agents are available to
order through your Miele Dealer/
Chartered Agent, the Miele Spare Parts
Department or via the internet at
www.miele-shop.com.
,
Before any cleaning or
maintenance work is carried out,
disconnect the cooker hood from the
mains supply.
,
Halogen lamps get very hot
during use and remain hot for some
time after being switched off. The
hot lamps are also susceptible to
damage from damp cleaning. Wait a
few minutes after switching off
before commencing cleaning.
Housing
General notes
Warning: The surfaces and controls
are susceptible to scratches and
abrasions. Please observe the
following cleaning instructions.
^ All external surfaces and controls can
be cleaned using warm water with a
small amount of washing-up liquid
applied with a well wrung-out soft
sponge or cloth.
^ Wipe the surfaces dry using a soft
cloth.
Cleaning and care
Do not use too much water when
cleaning the controls. Water could
penetrate into the electronics and
cause damage.
Do not use:
– cleaning agents containing soda,
acids, chlorides or solvents,
– abrasive cleaning agents, e.g.
powder cleaners or cream cleaners
and abrasive sponges, as well as pot
scourers or sponges which have
been used previously with abrasive
cleaning agents. These will damage
the surface material.
Important for appliances with
stainless steel housing
(This infomation does not apply to the
controls).
Stainless steel surfaces can be cleaned
with a proprietary non-abrasive cleaning
agent designed specifically for use on
stainless steel.
To help prevent re-soiling, a
conditioning agent for stainless steel
can also be used. Follow the
instructions on the label, and apply
sparingly with an even pressure in the
direction of the "grain".
15