Miele DA 403 Çalıştırma ve Kurulum Talimatları - Sayfa 20

Havalandırma Davlumbazı Miele DA 403 için çevrimiçi göz atın veya pdf Çalıştırma ve Kurulum Talimatları indirin. Miele DA 403 36 sayfaları. Ventilation system
Ayrıca Miele DA 403 için: Çalıştırma ve Kurulum Talimatları (32 sayfalar), Ürün Boyutları (2 sayfalar), Kurulum Kılavuzu (2 sayfalar), Kullanım ve Kurulum Kılavuzu (36 sayfalar), Çalıştırma ve Kurulum Talimatları (32 sayfalar), Çalıştırma ve Kurulum Talimatları (36 sayfalar)

Miele DA 403 Çalıştırma ve Kurulum Talimatları
^ After cleaning, leave the filters to dry
on an absorbent surface before
replacing them.
^ When removing the filters for
cleaning, also clean off any residues
of oil or fat from the now accessible
housing to prevent the risk of these
catching fire.
When putting the grease filters back in
position, ensure that the locking clips
are facing down towards the hob.
If the grease filters are inadvertently
replaced upside down, insert a small
screwdriver blade into the slits to
disengage the clip.
^ After replacing the grease filters,
press the grease filter touch control
for approx. 3 seconds to re-set the
operating hours counter.
The indicator lamp will go out.
If the grease filters are cleaned before
the operating hours counter has
reached its maximum, the grease filter
touch control should be pressed for
approx. 6 seconds to reset the counter.
20
If the cooker hood is connected for
recirculation, a charcoal filter must be
inserted in addition to the grease filters.
It is designed to absorb cooking
odours.
It is fitted in the canopy above the

grease filters.

New filters can be purchased from
your Miele dealer or from the Miele
Spare Parts Department.
See back cover for contact details,
and "Technical data" for the model
number of the filter.
^ Before fitting or replacing a charcoal
filter, the grease filters must first be
taken out (see previous section for
instructions on how to do this).
^ Take the charcoal filter out of its
packaging.
^ Insert the charcoal filter into the
canopy. The tab for removing it
should be at the front.
When fitting for the first time:
^ Set the operating hours counter to
suit your requirements (see
"Operation").