Miele DA 5000 D Kullanım ve Kurulum Kılavuzu - Sayfa 25
Havalandırma Davlumbazı Miele DA 5000 D için çevrimiçi göz atın veya pdf Kullanım ve Kurulum Kılavuzu indirin. Miele DA 5000 D 32 sayfaları. Cooker
Ayrıca Miele DA 5000 D için: Çalıştırma ve Kurulum Talimatları (32 sayfalar), Ürün Boyutları (2 sayfalar), Çalıştırma ve Kurulum Talimatları (32 sayfalar), Çalıştırma ve Kurulum Talimatları (32 sayfalar)
Sayfayı Yazdır
Important: To avoid the danger of
toxic fumes, please observe the
Warning and Safety instructions.
This is especially crucial when using
the cooker hood at the same time as
another heating appliance which
relies on air from the same room.
The cooker hood should be installed
according to local and national
building regulations. Seek approval
from the building inspector where
necessary.
– Only use smooth pipes or flexible
hoses made from non-flammable
materials for the extraction ducting.
To achieve the greatest possible air
extraction with the lowest noise level,
please note the following:
– To ensure efficient air extraction, the
diameter of the exhaust ducting
should not be less than 200 mm.
– If flat ducting is being used, the
cross-sectional area must not be
smaller than the cross-sectional area
of the exhaust connection.
– The exhaust ducting should be as
short and straight as possible.
– Only use wide radius bends.
– The exhaust ducting should not be
kinked or compressed.
– Ensure that all connections are
strong and airtight.
Connection for air extraction
– Where ducting is horizontal, it must
be laid to slope away by at least 1
cm per metre. This is to ensure
that condensate cannot drain back
into the cooker hood.
– If the exhaust air is to be ducted into
the open air, the installation of a
telescopic wall vent or roof vent is
recommended.
– If the exhaust air is to be ducted into
a vent flue, the ducting must be
directed in the flow direction of the
flue.
Important.
If the exhaust ducting is to run through
rooms, ceiling space etc. where there
may be great variations in temperature
between the different areas, the
problem of condensation will need to
be addressed. The exhaust ducting will
need to be suitably insulated.
25