Allmatic B.RO X40 DISPLAY Manuel - Sayfa 9

Alıcı Allmatic B.RO X40 DISPLAY için çevrimiçi göz atın veya pdf Manuel indirin. Allmatic B.RO X40 DISPLAY 20 sayfaları. 4 channels rolling code receiver, with display

Sayfayı Yazdır

4.1.6 rtime - OUTPUT PARAMETERS

In this sub-menu, for each relay (r01, r02, r03 o r04) it is possible to change the activation duration (LIFE) and the output delay

time (dLy).

To change the parameters, please follow the procedure below:

4.1.7 def - PARAMETERS RESET

By accessing the item def it is possible to restore the default values of the receiver. This reset does not delete the password and the

transmitters registered in the memory except for the parameters of the default transmitter.

In order to proceed with the reset, move to the item def and then conﬁ rm with a long pressure of the MENU button. Keep pressed

until the display shows the value 0, then release the button. Keep pressed again the MENU button: a countdown starts d80, d79, ...,

d01, d00. Once the countdown ends, the reset has successfully been performed, and the display shows

4.2 Modif - TRANSMITTER PERSONALIZATION

By accessing the item ModiF it is possible to customize the transmitters in the memory.

In order to proceed with the change, move to the item Modif, and then conﬁ rm with a long pressure of the MENU button.

Keep pressed until the display shows the ﬁ rst position occupied by a transmitter (e.g. p0.0.0), then release the button. The positions

of the memory occupied by a transmitter are indicated by the presence of a point between the digits (for example P0.0.1).

The default transmitter, used during the learning (see section 3.1), is indicated in the memory as Pdef: it is possible to change its

characteristics as for any other remote control, but it cannot be moved/deleted/enabled.

Pdef is located before the position P000.

Use the UP (+) and DOWN (-) buttons to choose the desired transmitter, then conﬁ rm with a long pressure of the MENU button. To

know the location of a speciﬁ c transmitter, use the function SEE (see section 4.4) of the receiver.

Once the transmitter is conﬁ rmed, a sub-menu opens, where it is possible:

6-1620020

rev.0

Go to the menu item rtime.

Press and hold the MENU button

until the display shows:

Select the output with the UP (+) and DOWN (-) buttons of the receiver.

Press and hold the MENU button until the display shows:

Select the desired parameter with the UP (+) and DOWN (-) buttons.

Press and hold the MENU button until the parameter blinks.

Set the desired value using the UP (+) and DOWN (-) buttons.

Conﬁ rm the change with a long pressure of the MENU button

ITA

ENG

27/10/2015

The display shows:

FRA

ESP

DEU

POR

9/20