Miele PT 7401 Kullanım Talimatları Kılavuzu - Sayfa 30
Kurutucu Miele PT 7401 için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Miele PT 7401 36 sayfaları. Innovationm tumble dryer
Ayrıca Miele PT 7401 için: Kullanım Talimatları Kılavuzu (36 sayfalar)
Sayfayı Yazdır
Notes for the installer
Electrical connection
The electrical components of this machine
comply with IEC 335-1 and IEC 335-2-11.
The electrical connection may only be
carried out by a suitably qualified technician
in accordance with current local and
national safety regulations (BS 7671 in the
UK).
Please observe the wiring diagram supplied
with the machine (located behind the plug
connector cover), as well as the installation
diagram. These diagrams are important for
the correct electrical functioning of the
machine.
Please ensure that the voltage and
frequency of the machine as quoted on the
data plate comply with the on-site supply.
The machines are supplied ex-works as
follows:
PT 7251
13.5 kW
PT 7331
18
kW
PT 7401
22.5 kW
PT 7501
27
kW
PT 7801
36
kW .
Air inlet and exhaust connection
This machine must only be used when it is
connected to a suitable ducting system.
The installation site must be adequately
ventilated.
See installation diagram and installation
instructions supplied with the machine.
30
Steam connection
Steam connection must only be carried out
by an authorised installer. See installation
diagram and installation instructions
supplied with the machine.
Gas connection
This work must be carried out by an
authorised person in accordance with local
and national safety regulations. This must be
a Corgi registered technician in the UK.
See installation diagram and installation
instructions supplied with the machine.
,
The earth lead (N) and phase
conductor (L) must be connected
correctly.
The gas group to which the machine has
been set at the factory is given on the Gas
Data label on the rear of the machine.
If the machine is converted for a different
gas group, or to liquid gas, a conversion kit
is required. This is available from the Spare
Parts Department. When ordering please
quote the model and serial number of the
machine, as well as the gas type, group and
connection pressure in the country of
installation.
Please follow the installation instructions
carefully. To ensure safety any conversion
work must only be carried out by an
authorised technician, e.g. Corgi registered
in the UK.
,
Do not attempt to repair or work on
gas heated machines yourself! Any repair
work may only be carried out by an
authorised technician. In the event of a
fault please contact the Miele Service
Department.
,
After setting up and connecting the
machine ensure that all outer casing parts
are correctly fitted back into position.
M.-Nr. 06 533 441