Miele T 1302 - ANNEXE 86 Kullanım Talimatları Kılavuzu - Sayfa 36

Kurutucu Miele T 1302 - ANNEXE 86 için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Miele T 1302 - ANNEXE 86 40 sayfaları. Vented dryer

Sayfayı Yazdır

The overall duct length will determine

the duct diameter.

^ Measure the actual duct length

needed to go from the dryer's

exhaust connection to the vent outlet:

1. Establish the number of elbows or

bends necessary, noting the type of

bend, angle and radius involved

(see Table).

2. Add the additional duct length (as

derived by using the values

specified in the table) and the actual

duct length to get the effective

length.

Maximum effective duct lengths:

4" (100 mm) diameter

5" (125 mm) diameter

6" (150 mm) diameter

Using the ring adapter up to an

effective duct length of 33 ft (10 m) and

a standard duct diameter of 4"

(100 mm) will provide optimal drying

times and energy consumption.

Do not use the ring adapter if the

effective duct length is more than 33 ft

(10 m).

Effective duct lengths over 66 ft (20 m)

require a larger duct diameter.

Longer ducts may lead to slight

decreases in dryer efficiency if the

necessary duct diameter is not

employed.

66 ft (20 m)

132 ft (40 m)

328 ft (100 m)

– Check with your local building code

to determine the maximum allowable

duct length.

– Use flexible metal pipe or rigid metal

pipe for venting. Non-metallic flexible

hose should not be used, it is a

potential fire hazard.

– For best drying results avoid extra

long ducting with too many bends,

angles or tight corners.

– The shorter the exhaust ductwork,

the more efficient the dryer will be.

Expelled air is slowed down in the

ducts due to friction against the inner

walls. The shorter and smoother the

inner walls are, the less friction will

be created.

– An elbow or bend creates more

friction than a straight duct. An

additional duct length factor must be

added for each elbow or bend (see

Table). This factor expresses the

resistance of the bend in terms of a

straight length of duct.

The additional length factor is then

added to the existing duct to give the

effective length.

A larger duct diameter helps reduce

friction. Therefore the duct diameter

and length should be increased

simultaneously.