Miele T 1526 Teknik Bilgiler - Sayfa 21

Kurutucu Miele T 1526 için çevrimiçi göz atın veya pdf Teknik Bilgiler indirin. Miele T 1526 42 sayfaları. Vented dryer
Ayrıca Miele T 1526 için: Kullanım Kılavuzu (28 sayfalar), Kullanım Kılavuzu (28 sayfalar)

Sayfayı Yazdır

T 15xx Dryers

The fan motor (Figure 4-3, Item 4) is a bi-directional 120VAC motor. Directional

switching for the motor is performed within the power electronic. Assistance to

the motor during startup is provided by the motor start capacitor (Item 3).

The fan motor provides drive to the drum via a drive belt and reduction pulley

(Item 1) mounted on the motor bracket (Item 2).

The fan motor also provides direct drive to the fan impeller (Item 6) within the fan

housing (Item 7). As the fan impeller rotates, airflow is created and draws heated

air from the heater bank, across the drum and through the filter(s). The air exiting

the fan housing is routed to the vent system (or through the heat exchanger on

condenser dryers).

Figure 4-4: Drum Drive Belts and Reduction Pulley

4.4

Residual Moisture Setting

There are two variables that determine dryer run time: initial moisture content in

the laundry and the program selected.

At the beginning of the cycle, the moisture content within the laundry is measured

by the residual moisture sensor. This value is used by the electronic to calculate

the approximate program duration.

During drying, the level of moisture within the laundry decreases and is reflected

by the status of the drying-stage LEDs. When the moisture within the laundry

reaches the selected program value the dryer enters the cooldown phase,

followed by the anti-crease mode.

Important!

The electronic limits all moisture-sensing programs to a maximum duration

of 240 minutes. Should 240 minutes be reached, the cooldown phase is

initiated; however, the anti-crease feature is skipped when this occurs.

The "Cooling down" LED remains illuminated until the appliance is shut off

via the on/off button.

1 Drum

2 Drum drive belt

3 Belt (motor to pulley)

4 Fan motor (M5)

Technical Information