Miele T 6185 Kullanım Talimatları Kılavuzu - Sayfa 16
Kurutucu Miele T 6185 için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Miele T 6185 20 sayfaları. Miele t 6185 tumble dryers operating instructions
Sayfayı Yazdır
Notes for the installer
The machine can be levelled by adjusting the
screw feet.
Once levelled the discs must be turned with a
screwdriver against the machine's base plate.
The electrical connections to the dryer must
be in accordance with instructions given on
the installation diagram and comply with local
regulations.
Once installed in position all detachable outer
casing parts must be attached again.
Electrical connection
This machine has been constructed in accord-
ance with current safety standards and com-
plies with the following standards: IEC 335-1
and IEC 335-2-11.
The electrical connection may only be carried
out by a fully competent person in accordance
with local and national safety regulations.
WARNING
THIS APPLIANCE MUST BE EARTHED.
Pay attention to the switching diagram sup-
plied (located in the machine behind the con-
trol panel) and the Installation diagram. These
diagrams are important for electrical connec-
tion.
The dryer may only be connected to the same
voltage and rated load as shown on the data
plate.
The electrical rating is usually set to 8.1 kW
ex works. Connection should be made via a
suitable isolator, with an on-off switch which is
easily accessible for servicing.
Ensure the leads for N and phase L are cor-
rectly connected. Do not transpose.
Connection must be undertaken by a fully
competent person.
All removable outer housing parts must be
refitted after electrical connection has been
made.
Gas connection
The gas connection may only be carried out
by a suitably qualified (e.g. Corgi registered)
engineer, in accordance with local and na-
tional safety regulations. The enclosed instal-
lation diagram and the installation instructions
for gas must be followed to ensure correct gas
connection.
Safety regulations demand that a pressure
test nipple is installed near a gas dryer to
allow an engineer to test the pressure follow-
ing servicing.
Please pay attention to the installation dia-
gram and instructions supplied with the ma-
chine. These are important for the connection
to gas.
The gas group to which the machines have
been set at the factory is given on the Gas
Data sticker affixed to the rear of the machine.
16
«M.-Nr.04832650/02 - GB - »