HP 3000 Series Kurulum Kılavuzu - Sayfa 24
Masaüstü HP 3000 Series için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. HP 3000 Series 42 sayfaları. 9x9 to k class conversion
Ayrıca HP 3000 Series için: Manuel (25 sayfalar), Yükseltme Kılavuzu (19 sayfalar), Manuel (20 sayfalar)
Series 44/48 to 58 Memory Upgrade
, 6.lnstalled the CPM-2 PCA in slot 10, the CPS-F PCA in slot II, the G IC PCA in slot 14, and the ADCC PCA in slot
15.
7. Reconnect the appropriate at J I, J2, and J3 of the CMP-2, the CPS ALU-F, the GIC, and the ADCC in slots 10, II,
12, 14, and 15 respectively.
8. Attach the new card cage configuration label over the existing card cage label. Verify that the new label correctly
identifies the new card cage configuration.
MEMORY INSTALLATION
Memory can be installed in two configurations. If there are no INPs in card cage 2, all memory is installed in card cage
2. If there are any INPs and associated GICs in card cage 2, all memory is installed in card cage I.
Memory Installation - No INPs In Card Cage 2
Materials used in this procedure are the S58 Memory Controller PCA (P
IN
30172-60001),4 MB Memory PCAs{P
IN
30479-60001),2 MB Memory PCAs
(PI
N 30478-60001), existing I MB Memory PCAs
(PIN
30161-60001), and a 9
board FCA (P
IN
30094-60002). The 256 kb Memory PCAs (P
IN
30092..6000
I)
are not supported. Up to five memory
PCAs are supported, for a maximum of 8 MB of memory.
NOTE
A Series 44/48 with a single card cage must have a second card cage (30087 A) to be upgraded to a Series 58. Install all
memory PCAs in card cage 2.
See Figure 2-2 while performing the following procedure.
I. Remove the flat cable at J I on the Memory Controller(s) and memory PCAs.
2. Remove the Memory ,Controller(s) from slot 9 in card cage I andl or slot 8 in card cage 2 and remove the memory
PCAs from slots I through 8 in card cage I
and/or
slots 9 through 16 in card cage 2.
3.0n the backplane of card cage I, set the
MEMI
NO MEN switch to the NO MEN position. On card cage 2, set the
switch to MEM.
~
4. Set the S58 Memory Controller configuration switch (located near the right backplen edge of the PCA) so that all
three switches are in the down position. See Figure 2-3 for switch positions.
2-4