HP 8530w - EliteBook Mobile Workstation Kurulum ve Yapılandırma Kılavuzu - Sayfa 15

Masaüstü HP 8530w - EliteBook Mobile Workstation için çevrimiçi göz atın veya pdf Kurulum ve Yapılandırma Kılavuzu indirin. HP 8530w - EliteBook Mobile Workstation 18 sayfaları. Hp elitebook mobile workstation
Ayrıca HP 8530w - EliteBook Mobile Workstation için: Broşür ve Teknik Özellikler (8 sayfalar), Quickspecs (36 sayfalar), Kullanıcı Kılavuzu (15 sayfalar), Broşür ve Teknik Özellikler (4 sayfalar), Ağ Kılavuzu (16 sayfalar), Teknik Özellikler (4 sayfalar), Aksesuar Kılavuzu (2 sayfalar), Broşür ve Teknik Özellikler (6 sayfalar), Kullanıcı Kılavuzu (27 sayfalar), Kurulum Kılavuzu (19 sayfalar), Genel Bakış (16 sayfalar), Manuallines (12 sayfalar), Yazılım Kurulum Kılavuzu (8 sayfalar), Manuallines (6 sayfalar), Manuel (20 sayfalar), Manuallines (7 sayfalar), Kullanıcı Kılavuzu (28 sayfalar), Quickspecs (47 sayfalar)

d. HTTP Digest credentials

e. HTTP Negotiate credentials

Other options can be set depending on S&CS implementation.

33) The system goes from In-Setup phase to Operational phase. AMT is fully operational. Once in

the Operational phase, the system can be remotely managed and can be provided to the

end-user for regular use.

Check with your management console supplier for information on how to prepare your Setup and

Configuration Server.

Return to Default

Return to Default is also know as Unprovisioning.

An AMT Setup and Configured system can be unprovisioned. It is done through the AMT

Configuration Screen and the Un-Provision option.

1) Go into Un-Provision.

a. Select Full Unprovision.

Full unprovisioning is available for SMB mode provisioned systems. It will return all

AMT Configuration settings to factory defaults. It does not reset ME Configuration

settings or passwords.

Full and Partial unprovisioning is available for Enterprise mode provisioned systems.

Partial unprovisioning will return all AMT Configuration setting to factory defaults

with the exception of the PID and PPS. It does not reset ME Configuration settings or

passwords.

b. Un-provisioning message will appear. This usually takes about one minute.

c. After unprovisioning is done, control is passed back to the AMT Configuration

screen.

Notice that the Provisioning Server and Set PID and PPS options are available again

since the system is set to the default Enterprise mode.

2) Return to previous menu.

3) Exit.

a. Select Y.

4) System will reboot.

Important Note: The system will need to be Setup and Configured again. The system cannot be

remotely managed until it is Setup and Configured again.

Full Return to Factory Defaults

For AMT 2.x, once the MEBx password has been changed, the unit can not be returned to the factory

default state without a service call.

For AMT 4.x, once the MEBx password has been changed, the unit can be returned to the factory

default state by enabling the "Unconfigure AMT on next boot" option in F10.