Miele S 246i Kullanım Talimatları Kılavuzu - Sayfa 3

Elektrikli Süpürge Miele S 246i için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Miele S 246i 36 sayfaları. Miele s246i: user guide
Ayrıca Miele S 246i için: Kullanım Talimatları Kılavuzu (36 sayfalar), Kullanım Talimatları Kılavuzu (36 sayfalar)

Miele S 246i Kullanım Talimatları Kılavuzu
When using an electrical appliance, basic precautions should always be followed,
including the following:
Check the voltage rating of the
vacuum cleaner before connecting
the power cord to an electrical outlet.
Your power source should correspond
with the voltage rating plate located on
the underside of the vacuum. Use only
household AC outlets. Never use DC
power sources. If you are not sure of
your home's voltage supply, consult a
qualified electrician. Connecting the
vacuum cleaner to a higher voltage
than indicated in these instructions may
result in damage to the vacuum cleaner
or injury.
To reduce the the risk of electric
shock, this appliance has a polar-
ized plug (one blade is wider than the
other.) This plug will fit in a polarized
outlet only one way. If the plug does not
fit fully in the outlet, reverse the plug. If
it still does not fit, contact a qualified
electrician to install the proper outlet.
Do not alter the plug in any way.
A damaged vacuum cleaner can
be dangerous. Check the packag-
ing, the vacuum cleaner and accessor-
ies for any signs of damage. Do not use
a damaged appliance.
Do not use with a damaged cord or
plug. If the appliance is not work-
ing as it should, has been dropped,
damaged, left outdoors or immersed in
water, bring it to a service center.
Do not use on people or on
animals.
Do not use outdoors or on wet
surfaces. Only
be vacuumed.
Only use the vacuum as described
in this manual. Use only Miele
recommended accessories.
The manufacturer cannot be held
responsible for damage caused by
non-compliance with these "Important
Safety Instructions". This appliance is
intended strictly for household use only.
This vacuum should not be used to
arrest or retain any hazardous
materials.
surfaces should
3