ALLNIC AUDIO L-3000 Kullanıcı El Kitabı - Sayfa 6
Amplifikatör ALLNIC AUDIO L-3000 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. ALLNIC AUDIO L-3000 10 sayfaları. Line stage preamplifier
Ayrıca ALLNIC AUDIO L-3000 için: Kullanıcı El Kitabı (12 sayfalar), Kullanıcı El Kitabı (11 sayfalar), Kullanıcı El Kitabı (11 sayfalar)
Sayfayı Yazdır
recommended for such applications to clean
the contacts from time to time as you deem
appropriate.
INITIAL SET-UP
A.
LOCATION, LOCATION, LOCATION
Like all audio products using tubes, the Allnic
Audio L-7000 needs to be placed on a solid
stand in a location that provides for good air
circulation around the preamplifier.
•
DO NOT cover the top of the L-7000
preamplifier.
•
DO NOT place the unit on carpet or
foam.
•
DO NOT subject the unit to knocks and
shocks as you move it around. This
advice is meant
particularly for those who may want
to place the L-7000 on some kind of
after-market isolation feet or similar
devices. Dropping one side of the
L-7000, or the whole unit, is not a
good thing to do.
•
DO NOT place the unit near a strong
light or heat source.
•
DO NOT place anything heavy on the
unit. DO NOT allow rubber or vinyl
materials to rest on the unit's chassis
for long periods of time. This could
discolour the metal.
•
DO place the unit on a shelf or stand
that is stable and not subject to
vibration or sudden shock.
•
DO consider using a high quality
power cord and inter-connects, both
inputs and outputs. The L-7000 is a
highly sensitive piece of electronic
equipment designed for neutrality and
will output what you put into it.
•
DO try to place the L-7000 away from
major sources of RFI and EMI; though
well shielded, the L-7000 will function
best
away
transformers and other sources of
such interference.
B.
POWER CONNECTION
The L-7000 uses a standard three prong male
IEC connection for AC input. You need to use a
power cord with a female three prong IEC
connector at one end.
To the left of the IEC connector (facing the left
side of the unit as in Figure 1), there is a power
on-off switch. Leave this switch in the OFF
position – that means the switch is pressed
"down" at the bottom - while you make all
initial connections.
The L-7000 you have purchased is set
internally for AC 110 or 220 volt – 60 HZ
operation. There is no way to change this to
another AC setting without return of the unit
to the factory for re-wiring, at the owner's
cost, including transport both directions.
C.
INPUTS
There are five (5) inputs. Line 1 and Line 2 are
balanced connections (XLR type connectors).
The remaining 3 line inputs are RCA type
single-ended connections. None of the inputs
is intended especially for connection to any
particular device.
NO PHONO STAGE - The L-7000 is a line stage
preamplifier and does NOT have a built in
phono preamplifier section. You will need a
phono preamplifier if you want to use a
turntable with the L-7000. You can connect
your phono preamplifier to any of the five
inputs, provided you have the appropriate
types of connections or adaptors.
The
L-7000
has
manufactured to work most synergistically
with
Allnic
Audio
from
large
power
been
designed
and
phono preamplifiers,