Allo RemoteControl BERNER Talimatlar

Uzaktan Kumanda Allo RemoteControl BERNER için çevrimiçi göz atın veya pdf Talimatlar indirin. Allo RemoteControl BERNER 2 sayfaları.

INSTRUCTIONS

BERNER

Assigning a button function:

The radio receiver has two channels for the control of two functions. Before

you can use the hand transmitter(s), you must assign the desired function in

the radio receiver to a button on the hand transmitter

Assigning a button function for channel 1:

1. Briefly press the P button (programming button) on the receiver. The LED

will begin to light up.

2. Press the desired button on the hand transmitter for at least three seconds

until the LED goes out.

3. Release the button. The receiver is ready to receive

Assigning a button function for channel 2

1. Briefly press the P button (programming button) on the receiver. The LED

will begin to light up.

Visit our website: www.Alloremotecontrol.com

2. Press the P button again. The LED will go out and then light up again.

3. Press the desired button on the hand transmitter for at least three seconds

until the LED goes out.

4. Release the button. The receiver is ready to receive

Checking programming:

Press the programmed button on the transmitter

The command will be issued and the LED on the receiver will light up

Note: There must be a distance of at least 1 m between the transmitter and

the receiver. If the hand transmitter does not work, try to assign a button

function to the channel again

Visit our website: www.alloremotecontrol.com