Allo RemoteControl NICE HSTSA1 Talimatlar

Tuş takımı Allo RemoteControl NICE HSTSA1 için çevrimiçi göz atın veya pdf Talimatlar indirin. Allo RemoteControl NICE HSTSA1 2 sayfaları.

INSTRUCTIONS

NICE HSTSA1

HSTSA1 is a tabletop or wall-mounted support for the HSTS2 touchscreen

keypad. It has two rechargeable batteries and a battery charger for recharging

them (they are recharged when the touchscreen keypad is mounted on its

support). This product is part of the Nice Home System alarm system. Any use

other than the use described in this manual should be considered prohibited!

Wall mounting:

• Check that the surface on which the product is to be mounted is sufficiently

robust.

• Check that the power supply cable can pass through the opening in the

centre of the support fig. 1.

• Do not install the support close to a heat source.

01. Mark the anchorage points on the wall, drill holes, insert the screw anchors

provided and pass the power cable through the opening in the centre of the

support (fig. 1/A-B-C); 02. Fasten the support in place with the screws

supplied (fig. 1/C);

03. Connect up the micro USB connector of the power supply unit provided

Visit our website: www.Alloremotecontrol.com

(fig. 1/D);

04. Hook the support onto the wall and insert the touchscreen keypad (fig.

1/E).

Warnings – Place the support on a flat surface where it will be protected

against accidental falls. Assemble the tabletop support: 01. Insert part (b) into

support (a) as shown in fig. 2/A; 02. Slide bracket (b) upwards as shown in

fig. 2/B; 03. Connect up the micro USB connector of the power supply unit

provided (fig. 2/C)

Visit our website: www.Alloremotecontrol.com