Chromalox CVCHS-201 Kurulum, Çalıştırma ve Yenileme Parça Tanımlaması - Sayfa 2
Elektrikli Isıtıcı Chromalox CVCHS-201 için çevrimiçi göz atın veya pdf Kurulum, Çalıştırma ve Yenileme Parça Tanımlaması indirin. Chromalox CVCHS-201 2 sayfaları. Circulation heaters
Sayfayı YazdırWARNING: Type CVCHS Circulation Heaters are
equipped with INCOLOY
tered in a CVPVC pipe body. It is the responsibility of
the user to know the chemical composition of the
corrosive solution and the character of the materials
entering the solution as well as the corrosive effect
of the solution upon the heating elements and cham-
ber. Chromalox cannot warrant any electric circula-
tion heater against failure by sheath corrosion if
such failure is the result of operating conditions
beyond our control.
1. WARNING: Hazard of Shock. Disconnect all power
before servicing heater.
2. If automatic reset cutout fails or will not reset, do not bypass.
3. Remove heating element assembly periodically to check heater
sheath for scaling, corrosion or excessive oxidation. Correct
operating conditions to minimize sheath deterioration.
Model
Volts
CVCHS-151
120
CVCHS-151
240
CVCHS-201
120
CVCHS-201
240
CVCHS-251
120
CVCHS-251
240
CVCHS-301
120
CVCHS-301
240
Note: When ordering parts for Model Numbers suffixed by "XX" or any other letter or letters not specifically identified on this instruction sheet, order Renewal Parts
on special order basis, giving name of part required, as well as the part number, model number and description of the complete circulation heater.
OPERATION
®
heating elements and cen-
MAINTENANCE
RENEWAL PARTS IDENTIFICATION
Heater Assembly
(Heating element
kW
and flange only)
1.5
155-058147-007
1.5
155-058147-008
2.0
155-058147-001
2.0
155-058147-002
2.5
155-058147-003
2.5
155-058147-004
3.0
155-058147-005
3.0
155-058147-006
Limited Warranty:
Please refer to the Chromalox limited warranty applicable to this product at
http://www.chromalox.com/customer-service/policies/termsofsale.aspx.
2150 N. RULON WHITE BLVD., OGDEN, UT 84404
Phone: 1-800-368-2493
WARNING:
1. Do not permit heater to operate when liquid has been drained
from chamber. Dry operation of the heater will cause failure and
possible fire hazard.
2. Terminal ends of heater must be protected from drippings, con-
densation, spray or direct spill-over of material. Their presence
at the terminals may damage heater electrical insulation. Liquid-
tight terminal enclosures are available to protect heater. Check
Factory.
4. Periodically check temperature control operation to insure accu-
rate and safe process operation.
5. Check all electrical connections periodically and retighten con-
nections which may have loosened in service. Replace wire and
wire terminals which shows signs of oxidation which would inter-
fere with establishment of reliable electrical connections.
Parts Common To All Heaters
Temperature Control Thermostat . . . . . . . . . . . . . . . . . . . .300-057474-001
Automatic Reset Cutout . . . . . . . . . . . . . . . . . . . . . . . . . . .300-026629-005
O-Ring Gasket P/N . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .132-057731-001
www.chromalox.com
TA - U0 - EF
Litho in U.S.A.