Grounding IMG1010 (DC Version Only)
The DC version of the IMG 1010 should be connected to a true earth ground. To connect
chassis to ground you will need the following equipment:
14-16 AWG machine tool wire (MTW) (green/yellow)
•
# 10 solderless crimp with two-hole mounting option to connect to grounding lug.
•
(Dialogic-supplied).
Procedure
1. Remove the two-hole grounding lug at the rear of the IMG 1010 by removing the
grounding screws.
2. Crimp the grounding wire to the lug. Re-attach the lug to the unit using the grounding
screws.
3. Attach the other end of grounding wire to either a grounding point on the mounting
rack or a building ground point.
For more information on connecting IMG 1010 to ground see IMG 1010-Installation
and Setup Guide > IMG 1010-Hardware Installation in Online Documentation.
Configuring Linux on GCEMS server
IMPORTANT: Please read and understand the IMG 1010 technical documentation prior to
performing any setup or installation procedures. The documentation can be accessed
through the following site:
If the IMG 1010 was purchased with the GCEMS Server then the Linux Red Hat Operating
System and GCEMS application have already been installed. Downloading System
Software to the IMG 1010 will be the next step. See paths below in Online Documentation.
IMG 1010-Installation and Setup Guide > IMG 1010-Software Installation and Setup
•
If server was not purchased, then a server must be configured with Red Hat Enterprise
Linux. The IMG 1010 supports Red Hat Enterprise Linux 3, Red Hat Enterprise Linux 4 and
Red Hat Enterprise Linux 5. Refer to the individual topics located under each of the
following headings in the Online Documentation for more information on configuring the
Linux Server.
IMG 1010-Installation and Setup Guide > IMG 1010-Linux Red Hat Installation
•
IMG 1010-Installation and Setup Guide > IMG 1010-Software Installation and Setup
•
IMG 1010-Installation and Setup Guide > IMG 1010-SD Card
•
Configuring Services on GCEMS Server
•
Dialogic Corporation
IMG 1010 Quick Start Guide
http://www.dialogic.com/manuals
Part # 07-8728-04
Page 6 of 9
Sayfayı Yazdır