Dialogic IMG 1010 Hızlı Başlangıç Kılavuzu - Sayfa 7

Ağ Geçidi Dialogic IMG 1010 için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Dialogic IMG 1010 10 sayfaları. Connecting dc power
Ayrıca Dialogic IMG 1010 için: Kurulum Talimatları Kılavuzu (6 sayfalar), Hızlı Başlangıç Kılavuzu (11 sayfalar), Hızlı Başlangıç Kılavuzu (18 sayfalar), Hızlı Başlangıç Kılavuzu (10 sayfalar), Kurulum Talimatları Kılavuzu (9 sayfalar), Hızlı Başlangıç Kılavuzu (4 sayfalar)

Connecting and Configuring Network Management Port 'CTRL 0'

The information below will provide the user with a basic setup sequence for connecting and

configuring the IMG 1010 along with the GCEMS server to download system software and

start configuring the IMG 1010 using the ClientView GUI. On the rear of the IMG 1010 are

the network interfaces. The first interface -CTRL 0- is a Fast Ethernet port dedicated to

network management. This port is connected to the GCEMS server and allows the GCEMS

server to access the IMG 1010.

1. Connect up the cables as shown in the first figure below.

2. Once the cables are connected, configure FTP and DHCP on the GCEMS server. Locate the

MAC address that is printed on a label located on the underside rear of the IMG 1010. This

will be used in the dhcpd.conf file creation.

For more information on how to set up the services refer to the topics under the following

sections in the Online Documentation

IMG 1010-Installation and Setup Guide > IMG 1010-Software Installation and Setup



If your setup requires using an SD card to load system software refer to the topics under the

IMG 1010-SD Card heading below in Online Documentation.

IMG 1010-Installation and Setup Guide > IMG 1010-SD Card



Dialogic Corporation

IMG 1010 Quick Start Guide

Part # 07-8728-03

Page 7 of 9