Dialogic 931-153-05 Hızlı Kurulum - Sayfa 2

Bilgisayar Donanımı Dialogic 931-153-05 için çevrimiçi göz atın veya pdf Hızlı Kurulum indirin. Dialogic 931-153-05 2 sayfaları. T1/e1/ip pci express fax board (single span)

Sayfayı Yazdır

Recognizing PCI Express Slots

The PCI Express slots in the computer chassis

appear as black slots. Figure 5 shows the different

variations of PCI Express slots. You can insert the

Dialogic® Brooktrout® TR1034 Fax Board into any

of the PCI Express slots shown in Figure 5.

PCI Express Board

Edge Connector

PCI Express x4 slot

PCI Express x8 slot

PCI Express x16 slot

Insert board connector into any of

these slots

Figure 5

PCI Express Serial Bus Slots

Connecting to the Telephone Service

An RJ-48C telephone jack on the board mounting

bracket (see Figure 6) provides the connection to the

T1/E1 service.

T1/E1 Connector A

T1/E1 Status LED A

T1/E1

- A

Ethernet

Ethernet Activity LED

Ethernet Connector

Ethernet Link LED

Board Status LED

BOARD

STATUS

Figure 6

Front View of Mounting Bracket

The TR1034 Fax Board, when used with a T1/E1

line, is approved as a DSX-1 device and must be

connected to the telecommunications network

through a PBX or CSU.

Warning: Do not connect the Ethernet cable into

the T1/E1 connector, or vice versa. It can cause

serious damage to the board.

Pinouts for the T1/E1 Connector

Pins 1, 2, 4, and 5 on the RJ-48C telephone jack

provide T1/E1 data paths to and from the board. The

connector pins are configured as shown in the table

below and in (Figure 7).

Signal Name

RJ-48C Pin

Transmit (TX) Tip

Transmit (TX) Ring

Receive (RX) Tip

Receive (RX) Ring

Indicates

RX Ring

RX Tip

No connection

TX Ring

TX Tip

No connection

Figure 7

T1/E1 RJ-48C Pinouts

Ethernet Specifications

Media: 10BASE-T/100BASE-TX

Connector: RJ-45

Pin 1 = TD+

Pin 2 = TD–

Pin 3 = RD+

Pin 6 = RD–

Cabling: Category 5 UTP up to 100m (328 feet)

Status Indicators

Ethernet Status LEDs

The Ethernet interface LEDs are located on the

mounting bracket Ethernet connector (see Figure 6).

Ethernet Status LEDs

Indicates

Activity

Activity on Ethernet.

(Flashing yellow)

Link (Green)

Link is established.

Dialogic® Brooktrout® Fax Board Status LED

The Board Status LED on the mounting bracket (see

Figure 6) indicates the overall status of the TR1034

Fax Board:

Board Status LED

Indicates

Off

Board has no power.

Flashing yellow

Board powered up and

ready to load firmware.

Steady red

Board powered up, but

failed tests.

Flashing yellow

Board is downloading

and green

firmware.

Flashing green

Firmware is downloaded

and the board is ready for

use.

T1/E1 Status LED

The T1/E1 Status LED on the bracket (Figure 6)

represents the T1/E1 service status as shown:

T1/E1 Status LED

Indicates

Off

The software has not yet

initialized the board with the

telephony configuration.

Green

Normal error-free operation;

layer 1 is up.

Red

Red alarm (loss of incoming

network signal).

Yellow

Yellow alarm (transmitting

alarm – board is failing to

synchronize with incoming

signal).

Green with

Clocking error, bipolar

flashing red

violation, cyclic redundancy

error, or other error.

Using the Dialogic® Brooktrout® TR1034 Fax

Board

Once you have installed the TR1034 Fax Board,

install and configure your fax software application

according to instructions included with the software.

After you have set up your software to support the

TR1034 Fax Board, you can send and receive faxes.

Serial Number and MAC Address

You can find the board serial number (2 letters and

9 digits) and MAC address (00A08A and 6 more

digits) on white labels on the back of the board.

Getting Help

Dialogic provides technical support for customers

who have purchased hardware or software products

from Dialogic. If you purchased products from a

reseller, please contact that reseller for technical

support. This equipment contains no

user-serviceable parts and is not intended for repair

by unauthorized personnel. If the equipment is

causing harm to the telephone network, the

telephone company might request that you

disconnect the equipment until the problem is

resolved.

To obtain technical support, please use the website:

www.dialogic.com/support

this document in whole or in part without permission in writing from Dialogic Corporation at

the address provided below.

All contents of this document are subject to change without notice and do not represent a

commitment on the part of Dialogic Corporation or its subsidiaries. Reasonable effort is

made to ensure the accuracy of the information contained in the document. However, due

to ongoing product improvements and revisions, Dialogic Corporation and its subsidiaries

do not warrant the accuracy of this information and cannot accept responsibility for errors

or omissions that may be contained in this document.

INFORMATION IN THIS DOCUMENT IS PROVIDED IN CONNECTION WITH

DIALOGIC® PRODUCTS. NO LICENSE, EXPRESS OR IMPLIED, BY ESTOPPEL OR

OTHERWISE, TO ANY INTELLECTUAL PROPERTY RIGHTS IS GRANTED BY THIS

DOCUMENT. EXCEPT AS EXPLICITLY SET FORTH BELOW OR AS PROVIDED IN A

SIGNED AGREEMENT BETWEEN YOU AND DIALOGIC, DIALOGIC ASSUMES NO

LIABILITY WHATSOEVER, AND DIALOGIC DISCLAIMS ANY EXPRESS OR IMPLIED

WARRANTY, RELATING TO SALE AND/OR USE OF DIALOGIC PRODUCTS

INCLUDING LIABILITY OR WARRANTIES RELATING TO FITNESS FOR A PARTICULAR

PURPOSE, MERCHANTABILITY, OR INFRINGEMENT OF ANY INTELLECTUAL

PROPERTY RIGHT OF A THIRD PARTY.

Dialogic products are not intended for use in medical, life saving, life sustaining, critical

control or safety systems, or in nuclear facility applications.

It is possible that the use or implementation of any one of the concepts, applications, or

ideas described in this document, in marketing collateral produced by or on web pages

maintained by Dialogic Corporation or its subsidiaries may infringe one or more patents or

other intellectual property rights owned by third parties. Dialogic Corporation or its

subsidiaries do not provide any intellectual property licenses with the sale of Dialogic

products other than a license to use such product in accordance with intellectual property

owned or validly licensed by Dialogic Corporation or its subsidiaries. More detailed

information about such intellectual property is available from Dialogic Corporation's legal

department at 9800 Cavendish Blvd., 5th Floor, Montreal, Quebec, Canada H4M 2V9. The

software referred to in this document is provided under a Software License Agreement.

Refer to the Software License Agreement for complete details governing the use of the

software.

Dialogic Corporation encourages all users of its products to procure all necessary

intellectual property licenses required to implement any concepts or applications and does

not condone or encourage any intellectual property infringement and disclaims any

responsibility related thereto. These intellectual property licenses may differ from country to

country and it is the responsibility of those who develop the concepts or applications to be

aware of and comply with different national license requirements.

Dialogic, Dialogic Pro, Brooktrout, Cantata, SnowShore, Eicon, Eicon Networks, Eiconcard,

Diva, SIPcontrol, Diva ISDN, TruFax, Realblocs, Realcomm 100, NetAccess, Instant ISDN,

TRXStream, Exnet, Exnet Connect, EXS, ExchangePlus VSE, Switchkit, N20, Powering

The Service-Ready Network, Vantage, Connecting People to Information, Connecting to

Growth and Shiva, among others as well as related logos, are either registered trademarks

or trademarks of Dialogic.