Dialogic DM/V1200A-4E1-PCI Hızlı Kurulum Kartı - Sayfa 2

PCI Kart Dialogic DM/V1200A-4E1-PCI için çevrimiçi göz atın veya pdf Hızlı Kurulum Kartı indirin. Dialogic DM/V1200A-4E1-PCI 2 sayfaları. Dm3 media boards

Sayfayı Yazdır

Pinouts for the RJ–48C

Network Interface

Jack on Bracket

Cable Connector

CHASSIS GROUND

Pin 1

CHASSIS GROUND

XMIT_TIP

XMIT_RING

CHASSIS GROUND

RCV_TIP

RCV_RING

8. Install the snap-fit ferrite clamp on all of the external

digital telephone cables as close as possible to the

cables' board connectors.

CAUTION: The ferrite clamp must be installed in

order to meet EMI requirements.

Ferrite Clamp

External Digital

Telephone Cables

Cables

Connect to the

PCI Board

9. Select a new PCI slot and repeat steps 3-8 for each

board you are installing.

10. Use the CT Bus cable to connect the board(s) you are

installing to other boards in the system.

NOTE: Your system may include both CT Bus and

SCbus boards. To connect both board types, you must

install a CT Bus/SCbus Adapter on one of the CT Bus

boards in a system. See the CT Bus/SCbus Adapter

Quick Install Card for installation details about the

Adapter and the bus cables. Contact your Dialogic

Sales Representative to order an Adapter.

11. Install CT Bus Termination Jumpers only on boards

located at each end of the CT Bus cable. See Physical

Description section.

12. Replace the chassis cover plate when finished and

reconnect the power cords.

13. Turn the power to the chassis ON.

CAUTION: If your BIOS is set to use Plug and Play

technology and there are ISA boards in your system,

an IRQ conflict can be created if a DM3 board is

assigned the same IRQ as an ISA board. This could

cause the machine to stop responding. You can prevent

this by entering the BIOS and reserving the appropriate

IRQs (those used by your ISA boards) for ISA use

only.

After Installing the

Hardware

After installing the Dialogic

hardware, proceed with the

software installation as described in the Dialogic

Software documentation (if applicable).

For technical specifications and product information, see

the Dialogic website,

http://www.dialogic.com/products.htm.

Warranty and Return

Information

Warranty Period

For specific warranty information for this board, refer to

the Warranty section of the Products page, located at this

URL: http://www.dialogic.com/warranties/.

Contacting Technical Support

Dialogic provides technical support for its products

through a network of value added distributors who are

trained to answer technical questions on installing and

configuring Dialogic

products. If you are unsure how to

contact your support channel, please call Dialogic in the

United States at 973-967-6600 (9am-5pm EST) and we

will assist in obtaining the appropriate support channel.

Outside the United States please refer to

http://www.dialogic.com/support/contact

local contact information. Dialogic also provides direct

support via Dialogic

Pro™ Services agreements. For

more details of direct support from Dialogic please refer

to: http://www.dialogic.com/support/DialogicPro.

Returning a Product

To return a board for warranty repair or any other returns,

please refer to the following:

http://www.dialogic.com/support/hwfaults.

Sales Assistance

If you have a sales question, please contact your

local Sales Representative or the Regional Sales Office for

your area. Address, telephone and fax numbers, are

available at the Dialogic website located at:

http://www.dialogic.com/contact.htm.

To purchase Dialogic

products, please refer to the

following website to locate the appropriate supplier:

http://www.dialogic.com/purchase.htm.

All contents of this document are furnished for informational use only

and are subject to change without notice and do not represent a

commitment on the part of Dialogic Corporation or its subsidiaries

("Dialogic"). Reasonable effort is made to ensure the accuracy of the

System

information contained in the document. However, Dialogic does not

warrant the accuracy of this information and cannot accept

responsibility for errors, inaccuracies or omissions that may be

contained in this document.

INFORMATION IN THIS DOCUMENT IS PROVIDED IN

CONNECTION WITH DIALOGIC

EXPRESS OR IMPLIED, BY ESTOPPEL OR OTHERWISE, TO

ANY INTELLECTUAL PROPERTY RIGHTS IS GRANTED BY

THIS DOCUMENT. EXCEPT AS PROVIDED IN A SIGNED

AGREEMENT BETWEEN YOU AND DIALOGIC, DIALOGIC

ASSUMES NO LIABILITY WHATSOEVER, AND DIALOGIC

DISCLAIMS ANY EXPRESS OR IMPLIED WARRANTY,

RELATING TO SALE AND/OR USE OF DIALOGIC PRODUCTS

INCLUDING LIABILITY OR WARRANTIES RELATING TO

FITNESS FOR A PARTICULAR PURPOSE,

MERCHANTABILITY, OR INFRINGEMENT OF ANY

INTELLECTUAL PROPERTY RIGHT OF A THIRD PARTY.

Dialogic products are not intended for use in medical, life saving, life

sustaining, critical control or safety systems, or in nuclear facility

applications.

It is possible that the use or implementation of any one of the concepts,

applications, or ideas described in this document, in marketing

collateral produced by or on web pages maintained by Dialogic may

infringe one or more patents or other intellectual property rights owned

by third parties. Dialogic does not provide any intellectual property

licenses with the sale of Dialogic products other than a license to use

such product in accordance with intellectual property owned or validly

licensed by Dialogic and no such licenses are provided except pursuant

to a signed agreement with Dialogic. More detailed information about

such intellectual property is available from Dialogic's legal department

at 9800 Cavendish Blvd., 5

Floor, Montreal, Quebec, Canada H4M

to obtain

2V9. Dialogic encourages all users of its products to procure all

necessary intellectual property licenses required to implement any

concepts or applications and does not condone or encourage any

intellectual property infringement and disclaims any responsibility

related thereto. These intellectual property licenses may differ

from country to country and it is the responsibility of those who

develop the concepts or applications to be aware of and comply

with different national license requirements.

Dialogic, Diva, Eicon, Eicon Networks, Eiconcard and SIPcontrol,

among others, are either registered trademarks or trademarks of

Dialogic. Dialogic's trademarks may be used publicly only with

permission from Dialogic. Such permission may only be granted by

Dialogic's legal department at 9800 Cavendish Blvd., 5th Floor,

Montreal, Quebec, Canada H4M 2V9. Any authorized use of

Dialogic's trademarks will be subject to full respect of the trademark

guidelines published by Dialogic from time to time and any use of

Dialogic's trademarks requires proper acknowledgement. The names

of actual companies and products mentioned herein are the trademarks

of their respective owners.

PRODUCTS. NO LICENSE,