Miller Auto Arc 160 Kullanıcı El Kitabı - Sayfa 21

Kaynak Sistemi Miller Auto Arc 160 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Miller Auto Arc 160 41 sayfaları.

Sayfayı Yazdır
Miller Auto Arc 160 Kullanıcı El Kitabı

5-4. Cleaning Or Repairing Drive Assembly

1

5-5. Replacing Gun Contact Tip

Tools Needed:
Tools Needed:
2
5
6
9
10
2
Y Turn
Off
cleaning or repairing drive
assembly.
1
Wire Spool
2
Nozzle
Cut welding wire off at nozzle. Re-
tract wire onto spool and secure.
3
Pressure Roll Arm
4
Cotter Pin
5
Pin
6
Screw
7
Bearing
Remove bearing. Install new bear-
ing and secure with screw. Reinstall
arm onto pin and secure with cotter
pin.
8
Screw
9
Drive Roll
Remove drive roll.
Align drive roll with flat spot on
shaft. Slide drive roll onto shaft and
secure with screw.
10 Wire Inlet Guide
3
7
Remove guide by pressing on
barbed area or cutting off one end
near housing and pulling it out of
hole. Push new guide into hole from
rear until it snaps in place.
Close door.
4
8
Ref. ST-801 991 / Ref. ST-801 872
Y Turn
Off
replacing contact tip.
1
Nozzle
2
Contact Tip
Cut off welding wire at contact tip.
Remove nozzle.
Remove contact tip and install new
contact tip. Reinstall nozzle.
1
power
before
power
before
Ref. ST-801 872
OM-187 924 Page 19