Miller ICE-40C Kullanıcı El Kitabı - Sayfa 24

Kaynak Sistemi Miller ICE-40C için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Miller ICE-40C 40 sayfaları. Air-cooled torches for plasma arc cutting
Ayrıca Miller ICE-40C için: Kullanıcı El Kitabı (40 sayfalar), Kullanıcı El Kitabı (38 sayfalar)

Sayfayı Yazdır

1. Section 8 − Parts List

5-6. Sequence Of Gouging Operation

Connect work clamp to a clean, paint-free

location on workpiece, as close to cutting

area as possible.

455

Hold torch at approximately

angle to workpiece.

OM-2239 Page 20

Set air pressure to 55 PSI (379 kPa) for gouging.

The pilot arc starts immediately

when trigger is pressed.

Raise trigger lock and press trigger. Pilot

arc starts. Move tip to within approxi-

mately 3/16 in (4.8 mm). Start gouging

across workpiece surface. Maintain

approximately a 45

angle to surface.

Release trigger. Postflow continues for

approx. 20 seconds after releasing trigger;

arc can be instantly restarted during postflow

by raising trigger lock and pressing trigger.

Ref. 803 640-A / 801 400-B